Lol!
Well, I'll be dosing 1-2 hours before even arriving at this party due to aMT's long duration. My only concern about putting it into solution was that it may make me want to deficate later on? I've never had an enema of any kind and I've never put any ammount of liquid in there so I just wanted to make sure it's not going to be a problem since I'll be doing this for the first time and then going to party with friends and strangers.
I think I will try putting it in 5ml of solution. Will I want to expell that 5ml at some point? Or is is such a small ammount of liquid that I won't feel like I have the squirts?
Thanks very much in advance! I have heard some impressive things about taking aMT this way. Although my current batch of aMT is pretty degraded. It's dark brown powder with a strong bad smell. I hope it goes into solution. It worked great orally at double the recommended dosages due to its degradation. I'm thinking about doing 40mg plugged plus probably a 4-subbed tryptamine or a 2C-X (undecided yet) once I get to the destination.
So how did it go? For me personally 5ml would definitely cause an urge to defecate.
[...]so be really careful to only use the 1 drop, I used 2 once and it started to burn and I had to "abort"
Just let it dry and there won't be any residual HCl left.

Now if you are in a hurry, I would personally do the math instead of using "a drop". I'll try to give you an example of how to do this.
Let's say you want to convert 100mg AMT to AMT HCl and you have 99% pure AMT and 37% HCl.
The molecular mass of AMT is 174.24 g/mol. The pKa should be around 10 or so, so we will be trying to use an equimolar amount of HCl for the conversion.
100mg / 174240mg/mol = 0.00057392mol
->We need 0.00057392mol HCl
The molar mass of HCl is 36.46 g/mol.
0.00057392mol * 36,46 g/mol = 0.021g
The density of 37% HCl is around 1.19g/ml. Since only 37% of that mass is HCl, we have 0,4403g HCl per ml of acid. Since we only need 0.021g we need:
0.021g / 0.4403g/ml = 0.0477ml
Now naturally it will be hard to draw up 1/20 of a ml into a syringe. Best way to go about this would be to put 3ml water into a glass, add 1ml of your acid. This will dilute the acid by a factor of 4, so you can use 1/5 of a ml instead.
Draw up 0.2ml, add it to your AMT. Stir. Either place the stuff on a flat dish on top of your heater, wait for the liquid to evaporate (shouldn't take long) and administer it.
I'm still surprised the HCl is kicking in faster than the freebase does, but if that's the case, this would be a good way to go about the conversion. Whether you use a little excess acid and wait for that to evaporate or you use a deficient amount and have some AMT freebase left is a matter of preference and also depends on what you intend to do with the product.