Opana ER MegaPOST
Hey all, I have a very special place reserved in my heart for opana

. After going through this thread and seeing certain questions being asked over and over again, I decided to compile a few preparation methods in this thread and elsewhere on the internet as well as my personal experience with Opana and put it in the form of a small FAQ (mainly derived from this thread and personal use.) However, I am only familiar with the peach colored 10mg Opana ERs. I am a bluelight newbie so I thought instead of an Opana thread I'd do a trial here with a megapost. If you are a mod feel free to edit my post as you see fit, I am not trying to break any rules or anything. If you notice anything wrong or would like me to add to or edit something in this, point it out to me in a PM or in this thread and I will change it. Basically this is all the important shit from this thread consolidated into one post, a thread re-cap if you will.
FAQ
What is the bioavailability of Opana?
Oral: 10%
Intranasal: 35-43%
IV: 95-100%
Rectal: ? see below
How do I prepare Opana ER for intranasal use?
Make sure your nasal passages are clear and relatively dry. Blow your nose and/or use a saline to clean it out. I always try to flush my nose before use somehow.
Method 1: Scrape the colored outer coating off lightly with a razor blade and crush as you normally would any other pill. I personally carry a glass vial with me to keep my powder in, and use the bottom of the vial in a circular grinding motion. Opana ER is relatively easy to grind compared to many pills after you take off the coating. To make the most of your Opana, alternate nostrils and space out your bumps.
Method 2:
This method may accidentally activate TimerX and gum up your pills if you do it incorrectly. Suck on the pill for approximately 6-8 seconds, and wipe off the coating with a paper towel. Crush and insufflate. Opana ER is relatively easy to grind compared to many pills after you take off the coating. To make the most of your Opana, alternate nostrils and space out your lines over a few minutes.
Method 3:
This is the last method you may want to use, it still works but leaves pieces of coating in your nose if you are not thorough. It will still work nonetheless. Crush pill with coating, pick out large pieces of coating with powder on them and rub them on your gums. Crush and insufflate. Opana ER is relatively easy to grind compared to many pills after you take off the coating. To make the most of your Opana, alternate nostrils and space out your bumps.
How do I defeat the TimerX mechanism to shoot Opana?
Alright, think of this as a complicated
CWE. Though it in no way involves water this mindset will help you grasp this. It is best to have done at least a CWE on Vicodin or Percocet etc. before you do this, and if you know how to shoot pills already that would also not hurt in helping you execute this. This is not my guide and has been pulled from
paingame's post on page 24.
Be careful as Opana IV is nothing to fuck with. You could die from an overdose very easily.
Opana Isopropyl Alcohol Extraction
Read through completely before attempting!
Materials:
2 - 1ml Insulin Syringes
1 - Bottle Isopropyl Alcohol (Important: Must be at least 90% abv.)
1 - Bottle H2O (Or any other clean water source)
2 - Large spoons
2 - Cotton Swabs
1 - Heat Source (Candle or Electric stovetop)
1- Opana
Note: The amount of solvent (alcohol/h2o)used for this prep were used for (1) 20mg pill. You may need to adjust more/less depending on how much OM you are planning on extracting, but prepping smaller amounts is preferable for maximum extraction. If you are using multiple pills, conduct multiple extractions. I have yet to shoot one of the 40's so i'm not sure how much bigger they are than the 20's but the amount of solvent needed shouldn't too much more.
The Process:
1. Scrape coating off of the pill. Do not wet it, you do not want saliva/water anywhere near the pill at this point.
2. Crush pill finely on a sheet of paper.
3. Transfer 4-5ml of Alcohol from the bottle to one of your spoons.
4. Add opana powder to spoon.
5. Stir vigorously for a few minutes, I used an orange needle cap, but anything small and hard will do. Stir as long as you can stand to do it. At least a few minutes, there will be a noticeable amount of particulate collected at the bottom of the spoon, but stir the alc until it gets cloudy and stops getting any more opaque.
6. Wet your cotton filter in the alcohol from the bottle, stick it on the tip of your syringe, and begin to draw up the solution, transferring this solution to the other spoon. You will have to do this multiple times, but the iso will begin to evaporate almost immediate so it will not be as much as you originally put in the spoon.
7. Once the alcohol solution is transferred, repeat the process again with another mL or so of alcohol to extract more OM from the solute. Once you have removed all the alcohol you should have a noticeably reduced pile of grainy sludge left over.
8. Take your alcohol solution and hold it over your heat source. This step should not be rushed. Take your damn time, you DO NOT want the alcohol to boil, and if you get it too hot you can risk it igniting. An electric stove or candle is preferred to a lighter because you will be heating this for a while. Hold the spoon at least a couple inches over the heat, moving it away if you notice if bubbles/vapors are starting to form. Alcohol boils at around the same temperature that opiates degrade (around 80-90C) so the lower the temp and the slower you do this the better.
9. This step should take at least 5-10 minutes. As the alcohol evaporates, you will notice that a film is starting to form on the spoon as it recedes. This film contains your oxymorphone. Complete the evaporation. Be careful not to let the film bubble/burn when the alcohol is almost gone, but also make sure that the alcohol is all evaporated, as you do not want to put this shit into your veins.
10. Have your second syringe filled all the way with your water in preparation of this step. Once you feel comfortable that the alcohol is gone, unload the water from your rig into the spoon. You may have to add a small amount of additional water, 20-30units, as the film seems to absorb a small amount, and to account for the slight evaporation that occurs with the heating in the next step.
11. Scrape the film off the sides of the spoon, and get it floating and immersed in the water.
12. Stir vigorously, you need to get the OM from the film into the solution. Stir for as long as you can, while moving the spoon on and off your heat source occasionally. Remember to not let it boil, but it is okay to get it hot as it will help the film dissolve. Continue with the step as long as you have the patience for. The film will never completely dissolve, but will break down into continually smaller pieces.
13. Take a fresh cotton, wet it with h2o, and stick it on the end of your second needle. Draw the solution into your rig.
14. This is your final product. Find a nice juicy vein and bang away.
Notes:
Either of the two extraction steps can be repeated to increase your yield or to perform a second wash.
The amount of alcohol I have been using has been largely trial and error, but the more you use the better the results seem to be.
The slower you heat the alcohol, the better your final product will be. A quick extraction yields a sticky, gloopy "film" that is very hard to break down, but a slower burn off of the alcohol allows the film to develop much more finely and seemingly easier to dissolve. I tested evaporating the alcohol quickly (5-10min) versus slowly (30-40min). The shot from the slow evap. was almost twice as strong as the shot from the quick one. There was a lot of left over particulate after drawing up the solution for the quick burn off, while there was barely anything left in the spoon after the slow one. The more patience you have the better. I ended up putting my stove on low, and propping the spoon over it on a text book, with another over the handle to hold it in place so i didn't have to stand there for forty minutes. If you are going to do this, just make sure to check on it periodically and adjust the height and temp if it seems to be going to fast or unreasonably slow.
Some work needs to be done with the step where you are mixing the film with water. Light heating seems to help break it down, but i feel like there is a better technique or an additional solvent that can be squirted into the solution at this point to aid in the break down of the film. However, extra steps also mean extra time, the potential for more fuck ups and loss. However, if you got a bunch to mess around with then go nuts and report on it!
The best method of dealing with the film seems to be creating a finer, weaker film through a very slow evaporation of the alcohol. You are shooting for a very thin residue, not a thick, milky skin. The film should look like very thin rings deposited around the edge of your spoon. It should look like rings of residue until you scrape it off the sides, when it's appearance will become more film-like in the water. Do not get discouraged when your alcohol is almost gone and this is all you see left on the spoon, you've done well! A very thin residue means your extraction was good and slow, and your oxymorph will break down extremely well in the water.
Conclusion:
This is a lengthy, somewhat time consuming procedure, but if executed with patience it yields a nice strong final product. Through some trial and error and experience it become a lot easier and you really get a feel for the process. Just don't rush it. The first thought that went through my head when i saw the film for the first time was, "wtf is this shit, there is no way this worked," but once i got that shot in me and felt that rush course through my veins it was all worth it.
Good luck and enjoy!
Can I plug Opana ER?
Yes. The bioavailability of this is currently unknown (at least to me and what I've searched so far) but it is not a waste compared to snorting. I have only done this a few times because snorting works well enough for me. You can follow the above procedure, and mix the final product to plug if you want to do it quickly. Also you can put it in an oral syringe (do not crush it) with a squeeze of lemon juice, leave it in there for 20 hours (though 15 or so should do fine, yet I'm very careful about not wasting my dear Opana) and administer as you normally would. Heating is not necessary but if you want to be extra thorough you could microwave it for 15 or so seconds before you administer it. I have read (but not tested) that you can just plug the pill itself and it will have a higher bioavailability than oral yet still have a time release function. Some users report a moderate opiate buzz that lasts for about 6 hours. If that is the kind of high you are alright with, go for it. For those of you with low to moderate tolerances and a few pills to try it out with, it may be enjoyable. I am currently nearing the end of a 4 month long break and will test it as soon as I am done with my break.
How do I make the most of my oral or intranasal Opana ER?
Whether I am snorting or eating the Opana, I always make sure to drink white grapefruit juice and eat a large, greasy, fatty meal. In a pinch a large fry or two from McDonalds should definitely do the trick. Eating a fatty meal can boost your bioavailability by up to 38%, so adjust your dose accordingly.
Warning: the following is only what I personally do and I am in no way recommending that you do this. You can die or overdose and end up in the hospital. I am just posting this because people will always try and potentiate opiates with alcohol and I am telling them where to stop and what a normal dose would be. This is my own personal experience, everyone is different, if you are going to try this then start at a small dose and work up. If I really am in the mood for a beating from my lady Opana, I will take 2-4 shots of vodka. But only if I've already had the fatty meal and the grapefruit juice. Never on an empty stomach. In studies it has shown that 240ml of 80 proof alcohol have increased Cmax 70% and if you were to ingest 240 ml of 40 proof alcohol has been shown to increase it 31%.
This is very dangerous, due to the fact that some people in the studies have shown it to increase by 270% and 260% respectively. You do not want to find out that you are one of those people too late.
Will Opana ER damage my lungs and nasal passages?
See the post above this and use it as a cautionary tale. Also keep in mind that they used it daily, and at huge amounts. If you don't use it daily and are careful you'll be alright with some minor recreational use. Breaks will allow your lungs to repair themselves, and as a side bonus keep your tolerance down. It is never good to snort Opana daily or any pill for that matter, but if you so choose to it's always best to sniff it lightly, and wash out your nose about an hour or two afterwards. Usually I'll either snort a small amount of water or use a water bottle to clean it out neti pot style. If you are going to do it daily, I suggest a combination of lightly sniffing a small amount, and plugging the rest. If you are able to handle doing an Acid/Base extraction on a large quantity, by all means do that, evaporate, and snort the finished product to avoid lung damage.
What will happen to my tolerance?
It will shoot the fuck up and fast. I used to be alright with about 4 Vicodin, now i have to CWE and drink at least 8-10 to feel a mild buzz and see a change in my pupils. I started off feeling super fucking high and euphoric from 5mg intranasally with none of the above mentioned potentiating, and now am taking between 10-20mg (depending on how high I want to be) all while using every single method I mentioned above. I don't even waste my time with many other opiates. Every once in a while I'll CWE Vicodin just because I have some lying around or plug some Dilaudid if I'm missing a good opiate high, but besides 6-8mg Dilaudid plugged it isn't worth it and every other opiate high leaves something to be desired, though they are still very satisfying I always end up comparing them to Opana. I also can't find Oxycodone in any form and have only been able to sporadically find Percocets so I can't give too much of a comparison between the two. It's kind of weird that all I can find is Dilaudid, Opana, and the odd bottle of Vicodin or Norco and no Oxycodone, because it seems like most people can find Oxycodone easily.
Well that's all for now. Do not PM me for pills. I won't even dignify it with a reply.