PART TWO
Step 5: Heat the powder until it is golden brown, JUST LIKE THIS.
View attachment 9116
Side Note: The objective of this process is to destroy the PolyOx bond with the oxycodone. The PolyOx breaks down at temps over 220-ish and the OC breaks down at a little over 400 degrees. So don't use a torch or a lighter because they are TOO HOT. This method works on the basis of heating it up to a point in between 220 and 400, destroying what we don't want while keeping what we do want.
Step 6: Once the glass completely cools to room temperature(VERY IMPORTANT) then take your razor blade and begin scraping up the dried-brown-goodness. Once scrapped up you will have to chop it up a little to get it into a powder but if you ground the pill somewhat fine initially and spread it out evenly on the glass then things shouldn't be too hard to separate.
View attachment 9117
View attachment 9118
Here is about how fine it should be if done properly...
View attachment 9119
Step 7: SERVE.
This is one entire OP 80 completed using this method, split into four 20mg lines.
View attachment 9120
If you do it right, there is no gelling up and you get the same nice drip as you would with the old ones. The only difference is this one didn't break your pocketbook.