reflexor
Bluelighter
- Joined
- Jul 12, 2022
- Messages
- 43
So I have just attempted to vape meth in a temperature controlled, up to 40W vape mod, with a 3ml mini-nautilus tank.
I can confirm: it works!
My method:
I have some questions for the community as well, would appreciate a comment below!
Thanks guys hope I helped a couple of you out, if you have any questions for me I'll do my best to respond
I can confirm: it works!
My method:
- Crush the glass, Only ever use powder to dissolve otherwise you'll be waiting far too long
- 100mg every 1ml of liquid - don't overdo it the first just in case u fuck up or it just doesn't work with you setup (100mg test first)
- Mix in powder straight into PG liquid (don't use VG as it is too thick to be vaped with a large solute like meth).
- You can heat beforehand, I have read reports saying thats a better way to go but its a lot of effort imo when the vape coil will heat the solution anyway
- Prime your coil: just swish the liquid around, or put it in a dropper and drop onto the cotton/wick in the coil
- Set your vape to 30W or lower (any higher and you waste ur product), temp control to 410 Farenheight/210 Celsius
- Take 4-6 second drags, direct lung
- Wait 30 seconds before next pull to avoid burning your wick - meth is hotter than nicotine when it vaporises!!!
- Post a comment here letting me know how you went
I have some questions for the community as well, would appreciate a comment below!
- How long is best to drag with a box mod of higher resistance (2 ohm)?
- At what point is it dangerous to take drag in regard to the amount of eliquid left in the tank?
Thanks guys hope I helped a couple of you out, if you have any questions for me I'll do my best to respond
