So I attempted this just a little while ago.
•Crushed 5 30mg pills of generic adderall mixed salts, total 150mg amphetamine salts.
•Added 2ml of water to the powder and stirred until thoroughly mixed.*
• I drew up the thick paste into the oral syringe, difficult to do but managed to get it all in there.
• Cut off a few .5 X.5cm squares from a sheet of ~.02 micron paper, stuffed them into a ~3in piece of medical tubing and put the tubing onto the tip of the oral syringe, making sure that it was air tight to prevent leaking.
• Pushed the thick paste through the micron paper stuffed tubing, a slow process requiring the intense pressure but not enough to break the filter paper.
•After about 15min I had squeezed almost every last drop out of the paste, leaving behind sandy orange filler.
• Drew filtered solution into a separate oral syringe and then squirted the solution into a cleaned oxymetazoline mist bottle that releases .1-.12mL per spray.**
RESULTS:
2 sprays of ~7.5mg/0.1mL in each nostril provided a rapid onset, feeling the effects within 10min and peaking at 45min. Very smooth come-up. Nose is clean even though filtering process did not remove everything I wanted (my micon paper is meant to be spun under pressure in order to work correctly, a completely different topic). The only problem is the that 2mL is a very small amount of liquid for a 15mL bottle, I will have problems within the next day or two when it starts to run low.
A larger size of 750mg/10mL will be necessary for this to be of use to me for portable use. But it is a convenient ROA and storage method. Thanks
@Shortec Stublue!!
*Amp has water solubility of 50-100mg/mL, so I used the median (75mg/mL) for this experiment.
**Using 75mg/mL as my amp solubility, a .1mL spray should deliver 7.5mg of amp. 2 sprays in each nostril should equal 30mg for my dose.