• Psychedelic Drugs Welcome Guest
    View threads about
    Posting RulesBluelight Rules
    PD's Best Threads Index
    Social ThreadSupport Bluelight
    Psychedelic Beginner's FAQ
  • PD Moderators: Esperighanto | JackARoe | Cheshire_Kat

The Big & Dandy N,N-DMT Extraction Thread - Elves are watching

Status
Not open for further replies.
for me sometimes there is still a worthwhile amount of DMT in the naptha...

What I would do is wash the naptha with an acidic solution, then pull the naptha and discard, then basify again and use new solvent to pull DMT again.

Basically you are getting rid of the junk, then reextracting the goods from your solution
 
IMAG0089.jpg


at fucking last. not a massive amount but looks clean. still a bit damp. lots of problems trying to extract this shit around my parents, freezer wouldnt go cold enough, no way to fan dry the stuff to speed up the evap without it being very suspicious. might give it a try over the weekend
 
now that you have done it the first time future extractions will go much more smoothly

you definitely want to let it dry out before giving it a go obviously
 
now dried and ready to smoke. looking for the right moment. infact its beautiful and snowy today, i might have to venture into some fields and find a nice place to smoke. only downside is i currently have a fucking hangover
 
IMAG0089.jpg


still a bit damp.

If your product is not dry, I would suggest not leaving it in a plastic bag, some of these solvents used can eat those bags quicker than you blink, but the real ones to worry about are the ones that degrade the bag slowly so you dont notice that when you smoke your DMT it is also smoking degraded plastic
 
and also smoking DMT wet with flammable solvents...

Definitely let that shit dry on a glass dish or suttin.
 
its properly dry now. it dried within a day in the plastic bag. bag doesnt look eaten away, or effected, i guess it could be though and contaminated my dmt with plastic. nevermind. this stuff is proper crystalline nice looking stuff, love it
 
Your questions are pretty ambiguous.

The time it takes depends on you. How much of the day are you spending extracting DMT? I can get a batch done from start to finish (dry product) in a day and a half.

The amount of DMT you extract depends on the quality of the source of DMT (percentage of DMT with in the source), how well you do the extraction, and most importantly how much of the source of DMT you use in your batch.

I usually would do a batch of 100g of mimosa hostilis root bark and end up with about a gram of DMT.
 
A gram of DMT from 100mg? That's an awful lot. It's about twice the standard 0.57% DMT concentration of mimosa.
 
To put it simply: a hell of a long time.

near a month on average I'd say

http://www.erowid.org/chemicals/dmt/extraction_guide1/dmt_extraction_guide1.shtml

naw ive come out with a decent batch of dmt in 3 hours. pretty good yield too, well maybe 5 or 6 hours for a good yield
also thats an ancient tek.

this works in a few hours:
- 1 HDPE Plastic Jug (Grocery Store)
- Water
- Vinegar/Muriatic Acid (Grocery Store/Hardware Store)
- Mimosa Hostilis (Your own source)
- Naptha (Ace Hardware/Hardware Store)
- Turkey Baster/Large Oral Syringe (Pharmacy)

1. Take the plastic jug, and put in 10ml of water to every gram of good quality powdered rootbark.
2. Add either HcL acid or vinegar. (Not too much; not too little)
3. Shake up every 5 minutes for 30 minutes-- very vigourously.
4. Add a gram of lye (sodium hydroxide) for every gram of root bark you used.
5. Shake up every 5 minutes-- and allow to sit for two and a half hours-- shaking vigourously for 2 minutes at a time. (Or for 24 hours shaking it up often-- doubling or tripling the yield).
6. Add 2.5ml of naptha for every gram of rootbark and let it sit for about 30 or 45 minutes shaking it up every 5 minutes, vigiously for two minutes at a time.
7. Allow to sit until you see a large seperation of naptha from the water.
8. Suction off with turkey baster or suck off with oral syringe. place this in another container. (if you cannot get any naptha squeeze the jug together to move it closer to the [thinner] top, and try again.)
9. repeat steps 6 to 8 three or four times, allowing each more time to sit (you can leave for 24 hours if you want the most out of the yield).
10. collect what you seperated (should be clear or offcolor naptha-- noen of the black shit) into seperate containers, with not much in each (small mason jars work best) and seal as airtight as possible and place them in your freezer on its coldest setting.
11. check back every few hours and when you see a decent clump of crystals formed you can scrape some out with a spoon and let them airdry quickly and use them or you can just wait.
12. after as long as your going to wait (stop when you are satisfied-- or wait 3 days to a week (after 3 days you got teh majority in my experiance) and then pour each over a coffee filter in a seperate cup-- this takes practice and do it quickly so the dmt does not melt back into the solution. dmt dissolves quickly when it thaws-- work as quick as possible.
13. allow the coffee filters to dry out and then scrap the crystals from them-- and then put the jars upside down on some others incase any drips out but then you can put these jars under a fan, i've noticed sideways next to a fan might work better, and let them dry out completely and then scrape them off and collect.
ive found this here gives a good yield of some good quality clean white dmt.

<3<3<3<3
 
A gram of DMT from 100mg? That's an awful lot. It's about twice the standard 0.57% DMT concentration of mimosa.

Hi, I am considering ordering some Mimosa hostilis inner root bark and want to make sure my math is correct.

The amount is 0.5lbs of bark. That translates to 226.80g.

That means, rounding down to 0.5%, I'd get around 1.13g DMT ??
 
No...

Well... Maybe if your rootbark came from Mexico - mexican Mimosa is shit (trust me I know).

If you got it from Brazil, or south America, then you can push it to between 0.8 - 1.1 if done with precision following a reputable tek.
 
Push the yield to 0.8 - 1.1 % ??

And yes, harvested from Brazil. And I am less concerned with squeezing everything out of it, especially being my first time, than with simplicity.

I have noted the Lazyman's Tek and, fuck, I forget the other.

Edit: Noman's Tek
 
Last edited by a moderator:
Status
Not open for further replies.
Top