• Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Safe prep technique for wax sustained release tablets

Fast always has so much knowledge to pass along...I envy the amazing knowledge of Organic Chemistry he possesses. It inspires me to learn it. FandB how did you get into this field? Did you get a degree in this?

Sorry for the off topic post....This should probably be a PM, but I had to get a little shite on me nose....
 
1) So, where did the binders disappear? I see there's just talk about toluene/ethanol + morphine sulphate ... (I mean the original post.)

2) How should you treat that morphine sulphate to make it soluble in water i.e. injectable? Someone said something about turning it to hydrochloride ... ? How do you do it?
 
Last edited:
What's left with the morphine sulphate are fillers like silicon dioxide - essentially it's just the morphine sulphate that'll go into solution with warm water. Everything else is removed in one way or another (mostly in soln in organic solvents), most importantly, the wax/slow release compounds which are so dangerous to health because of the possibility of embolism.

What's left, you just shake with warm water, then pass through a micron filter & voila, ready for use. Morphine sulphate isn't the most soluble morphine salt, but a saturated soln at room temp is somewhere around 25mg/ml of solution (according to the Merck Index, 1g of morphine sulphate dissolves in 40ml of water at room temp - it's effectively insoluble in eghanol/isopropanol and non-polar solvents)
 
Solubility

^ Some molecules can tak on extra H20 molecules , hence the pentahydrate.

Epsom salts can tak on extra H20 molecules to it. I think it comes this way though.

Morphine sulphate typically comes as the pentahydrate in pills, im not sure youll find anything else.

Oxycodone is soluble in alcohols enough to ruin something your trying to do with it, but then again so is morphine sulphate, not to the degree its soluble in water, but depending on your yeild, the alcohol will take some.

Thats not even including the fact that when you say isopropanol, which grade? what percent? anhydrous? You gotta include that or anyone following directions that contain an alcohol will go buy 70-91% rubbing alcohol and ruin what there doing. Not that someone who doesnt know to use anhydrous alcohol would be doing this anyway...so im probably just wrong :P

I have full faith in you, fastandbulbous, buddy :) , but im not injecting something that was previously in contact with an organic solvent. Inhaled, yes i would, but Thats me and im also crazy, as you can tell from older posts :P

Unless the pills cannot be crushed to a powder dry (some should be able to, some might not i know ive seen them), your better off just using temperature as a control for solubility and then filtering at X temperature to filter the desired component out. Thats a totally random plan though, youd have to go through the list of fillers in the pill brand in question to work through that.

In another thread i posted about the fillers in oxycontin and which were soluble or filterable, at what temp, and which were harmful or safe to inject. here

Filters introduce a bit of complication, I considered this when i posted the OC micron filter thing i did a few years go, but including solvents pushes this up a few notches.

Chem experienced, however, this is a great idea :) i just never had the courage to try using my chems on drugs i had just bought, filters worried me enough.
 
Oxycodone is soluble in alcohols enough to ruin something your trying to do with it, but then again so is morphine sulphate, not to the degree its soluble in water, but depending on your yeild, the alcohol will take some.

Have you looked up the solubility of morphine sulphate in ethanol or isopropanol - the solubility is so low that it's effectively insoluble (less than 1 in 1000 solubility). The alcohol is reagent grade (99 % +) unless otherwise stated; as it's available from lots of electronics outlets as degreaser & contact cleaner, it's not difficult to obtain.

but im not injecting something that was previously in contact with an organic solvent.

They've all been in contact with organic solvents at some point in their refining/processing. Morphine from opium will have been in solution in chloroform or methylene chloride at some point in it's isolation and they're nasty organic solvents. As long as you ensure that it has all been removed (via boiling water bath if needed - all solvents mentioned boil below 100'C at atmospheric pressure)


Unless the pills cannot be crushed to a powder dry (some should be able to, some might not i know ive seen them), your better off just using temperature as a control for solubility and then filtering at X temperature to filter the desired component out. Thats a totally random plan though, youd have to go through the list of fillers in the pill brand in question to work through that.
.

Doesn't work with wax matrix sustained release preparations as the tablet also tends to contain some sort of surfactant (which is why the water goes frothy when shaken) - that's one of the reasons for using alcohol - to remove excess toluene and the surfactant present.
 
Nope

Nope i havent looked up the solubility other than to say its slightly soluble, which is what the monograph for all the morphine pills say, other than that i didnt go looking for MSDS sheets. So yes, your right its insoluble in anyhydrous alcohol.


IM POSITIVE that you, fastandbulbous, can do it and be totally safe.

Id be concerned about the followers though, thats all.

My point is basically that you (not you, person X) have the chance of making the harm far far worse. It all depends on how good you are (and you yourself are good i know) however i do tend to put more trust in a mass produced FDA approved formulation, they can waste a few ounces of the stuff doing GC-MS over and over first.

Hell just 2 days ago i posted a meth freebase acid/base conversion, but i never intended that for injection either.

I know drugs are produced using toxic chemicals, im not one of the "meth is drain cleaner plus match stick heads and ACID maaan" idiots.

I took organic chem, but this kinda thing would totally stop me, i have a lot of faith in myself and my chem abilities, but thats my limit even as someone whos done a lot of chem reactions in the past.
 
For us less fortunate folk we got to work hard to mix up a shot

MildKandy said:
Too much work IMO. Rather get some dope or something more soluble.

-weez

Comments like this REALLY piss me off. Your very lucky that you have that option to choose dope instead. I live in Winnipeg, MB. Any one know were that is? Didnt think so, any way its a city in Canada. They say pandas are becoming extinked....well fuck the pandas H is a very endangoured species. I have only had one connect ever and he was having it mailed in from Vancouver(Junkie Capitol of Canada). Now im reminescing....ohhh those sexy off white rocks. SOOO much better than the prominant opiate(which still aint fun tracking down) Oxycontin. But hey I should be greatful for the amazing price i get on OC's 40mg for 7.50. The kid doesnt even kno the value of what he is sitting on. And im trying to keep it that way. But now im defiently rambaling...what was the point of this post againe... oh yeah MABY DOPE AINT A OPTION, or just maby he perferes morph OMG OMG . Seriously though WildFanny what was the point of that post I mean you are a fairly prominant and respected person on theses boards from what i can tell(but what the hell do i kno im canadian and cant spell or use correct puntuation). You should know better. Good GOD i would kill a man for some good skag. Congradulations on your hook up I truely envy you. Since I started methadone i have not had a decent high. Even from eating a WHOLE box of 100ug Fent Patches, I managed to catch a buzz but NOTHING LIKE IT COULD HAVE. NOW IM RAMBALING MORE. The more i ramble the crazier i get. Dont ya just love methamp hehe.....NOT. Thats the scene here in winnipeg Mostly shitty coke(stuff to call home about is literaly a once a year find) We got LOTS of meth. Lots of e to ranging from dirty and week and clean and strong. BUT I AM AN OPIATE MAN. I apologize MildKandy I needed to vent and those posts make me so jelous, lol sounds quite childish. ANY ONE FROM THE PEG HITTING UP BLUELIGHT E_MAIL ME (NOT NOT NOT looking for connects i already know its a lost cause and refused to get ripped off one more time) AT [email protected]. Hell any one from canada give me a shout. we can compare the local scene's and decide where to condrigate to. Im thinking VANCOUVER.......HEROIN...sorryyy i really am. been up all night on jib and i doubled my m'done this morning so i will cease this public glimpse into my slighlty different though process. See like seriously now wtf am I talking about. Im going to go try and masterbat(goddam 'done, but the methamp might just bless me with the ever so elusive power of ejaculation.
 
Hmmm I will start light with the bluelight nudity gallery. Then meander on over to Paradise Nudes.....once there....you are forever lost in endless porn.

Back on Topic, I just crush my pills (100mg MScontin) add 3-5 ml water depending on what equipment i got availiable

Then suck it all up into a 3 or 5 rig(no neeedle, but i like to pull through a filter at this point aswell.

Then pack another righ with cotton (well not literally pack)

then i like to add a larger gauge spike to to syringe with all the goods in it, and squirt that liqued euphoria into the rig with the cotton.

now be careful not to spill at this part, place a spoon under the bottem the bottem of the filter needle on slap that son of a bitch no good nothing but trouble and HIV plunger back into the rig and push the milky liquied through the extremely ghetto filter into a nice clean spoon that was pre cleaned and steralized with those fany little alky swabs.......phhhhhhhhhhhhhttttt. Sorry about that out burst it was uncalled for now where was I, oh yes...... Now listen very carefully the fate of junk earth if in your hands. You must use the one rig. The very same rig once used by suron himself. You must Suck up the contents of the spoon. I like to do one last filter, you can never be to safe when fighting the hordes of suran(that is his name right? or is it saruman?) Now it is all up to you, you must venture Mt Doomvien and plunge the one needle into it for good.


You see this is why i dont post much it gets out of control. BUT I REALLY NEED TO RUB ONE OFF(SORRY RUDE OBSENITY LADIES) I Have not had sex in over a week...dear god.....but thats another tale for another day. Rest well now young hobbits.
 
I know this is retarded but BUMP, i need opinions on my writing. Im actually in uni. But dont worry that wasnt any real stuff i do just fooling around. OH SHIT complete wrong forum.....
 
Top