Supposedly they can be IV'ed rather easily with the following method SWIM has already come up with a while back:
1) Remove coating.
2) Crush pill as finely as possible.
3) Place powder in spoon*(1). DO NOT add water.
4) Dry-heat powder with lighter/candle, but not so hot that the powder burns after 1-2 secs (keep flame low, not touching the spoon)
5) if done correctly, the powder should SLOWLY start changing color
6) When a small amount of smoke appears, quickly remove flame and shock the powder with COLD saline solution (salty water may work better)
7) Mix solution. It's normal for it to still have a "syrupy" consistency
8 ) Heat again and boil for a few seconds. Heat + salt water should breakdown the timed-release matrix. With oxycodone generics especially, the wax will start floating to the surface.
9) Drop med-sized cottonball in the solution*(2). It should absorb much of it*(3).
10) This will extract approximately 75-80% of the oxycodone/morphine from experience. Doing a rewash can be performed as there still will be a TINY amount of oxycodone/morphine unextracted from the wax*(4).
*(1) Note #1: the best type spoon to use is one that is thick. This is so that temperature spreads evenly -and still retains heat even after removed from flame. Something like a thin measuring spoon, bottom of a soda can, or tinfoil will NOT work properly.
*(2) Note #2: the cottonball will act as a "magnet" for any remaining wax, so a big-enough one is a MUST to prevent clogging.
*(3) Note #3: if the cottonball just seems to "float" on top of a gooey solution, it's likely that not enough heat was applied.
*(4) Note #4: a taste-test (though not precise) is a good way to tell if there is still some good stuff left behind. The taste should be *bitter* and not really salty (as this can be from the saline/saltwater used).