Cocaine Le Junk's Cocaine Purification Megathread v. The Final Word

[Le Junk]

looks fine. Are you planning on doing the A/B cleaning?

Some one needs to rewrite the instructions using more scientific instructions because if you follow the current ones you can really screw up your stuff. We need exact measurements and MOST importantly PH readings on the basic and acidic solutions. 10 drops of HCL can be VERY different amounts depending on the dropper you use. In my case it dropped the PH well below and ruined quite a bit of some good stuff. I believe the cocaine HCL will crystallize at ph 5.5. Also if you turn it into a freebase and use too much ammonia you will also have a reaction with your cuts. My best results so far produced beautiful results but I still put barely too much acid and it started to redissolve in the acetone. This resulted in a highly acidic (burned a bit and tore up my nose) but was highly active.

Since LeJunk is abstaining (more power to you bro!) will someone post some scientifically accurate lab notes PLEASE?

Thank you ikarma! Yes, everything is looking great so far, but if I personally continue to help, I'll end up getting hungry and want to try it again myself. And that's not good, considering I'm going on day # 45! Cha, ching!

So please, anyone wanting to add additional technical notes to this thread, please, by all means do so. Information is the key to success here...........

Le Junk

P.S. If I ever do fall off of the wagon, God forbid, I'll go ahead and edit the original thread, but until then, anyone with accurate information, please do add............

 

[epote]

ok one question.

how much of a difference quility wise does the simple aceton wash to the proper HCL->base->HCL gives? Is it so much that it actually is worth blowing up your house and the trouble of obdaining the chems?

also, that prosses would give you very pure cocaine hcl, but then again, some of the alkaloids are psychoactive in a good way, has anyone of you tried USP grade cocaine? I havnt obviously, but the author of "the pleasures of cocaine" says its way to edgy

 

[epote]

ah, aright, after sending a stupid e-mail to lejunk im kind of figuring things out. Sorry lejunk.

anyway, so, regarding the A/B extraction. Does ading ether to the mix makes things simpler? I.e. ether is added in order for the crystal formation to be more "spontaneous"?

why is there difference between the batches when adding the hcl acid in increments? I mean, what is the physical reason? Disturbed ph? If yes whats the problem?

can ether be substituted with another similar solvent?

 

[blowMEaway]

edit: for incoherence, at best.

 

[epote]

Yes, it's called anhydrous acetone. Unless you seriously know what you're doing, I would advise you substitute for that ether man. The acetone's no joke either, but ether, ehhh scary shit can happen pretty easily with that stuff.

And I'm glad to see this thread still moving along btw. But what is this rumor going around? 'TheGarbageMan' is on the wagon? Lol, must be some blackmail involved with that one. Doesn't seem like more than 45days since I almost blew up the house at 3am . But congrats on such an accomplishment nevertheless.

no aceton is used either way, swim was refering to ethyl alcohol or something similar.

swim know what ether is and how to handle it in any case, swim would buy diethyl ether with BHT and discard any ether not used afterwards.

but swim cant understand if ether does nothing why is it used in any case? And also what is the theory behind adding ether? I.E why adding a non pollar solvent help the procedure? Swim guesses that it has to do with helping the crystalazision but doesnt know why.

swim will keep on reading obviously

 

[pseudointellectual]

I'm pretty sure it speeds up the process after the solution no longer turns milky white with the addition of the ammonia/water mixture. you add the ether to the solution, shake it, then syphon off the ether layer (now contains cocaine), and it will dry much more quickly.

 

[pvdoakie]

Godbless you for genuinely wanting to get clean lejunk it deserves the utmost respect i wish the best of luck maintaining!

 

[Le Junk]

Godbless you for genuinely wanting to get clean lejunk it deserves the utmost respect i wish the best of luck maintaining!

Thanks my man! It's comin' up on 3 months as of the 2nd of Sept. I can actually talk about it now without wanting to do it. Pretty cool. Turns out I've been masking an apparent case of ADHD with my cocaine and getting prescribed d-amphetamine has completely changed my whole life. I guess the whole time I was doing cocaine I was really just enjoying the relaxation it gave me. Normally, my brains just swimming in confusion, and that completely cured it. And the buzz is very, very nice as well......................

later on, Le Junk

 

[pvdoakie]

Nothing like made in the USA pure lab grade amphetamine LOL. Dont over do it! I'm Definitely scripted the same thing and its oh so easy to take "just one more" haha. But yes its very effective if you use it in the right dose for ADHD.

 

[darckeen]

I read somewhere that you can use calcium chloride which is available as rock salt for disolving ice on roads to make acetone anhydrous, can anyone confirm this?

 

[BlueEclipse]

Alright even though i get some great coke here where i live (southern state) i figured i would give it a try and see what this is all about. Before i do that though i wanna kno what would be better?

A. just doing the acetone wash and letting it dry.

B. Doing the convert to freebase then do a/b conversion back to hcl.

IF im gonna do this im gonna do it right! Also i wanna kno has anyone tried Iv'ing it yet since they washed it? How was it let me kno or any other info you think i should kno. thanks in advance

 

[epote]

blueEclipse:

obviously if done properly the a/b extraction yealds a fine product (well yealds prety damn pure cocaine) the acetone wash just whases aceton solube impurities. In any case to inject anything it must be water solube so just dissolve it in water and filter it is my guess

 

[xxl]

IF im gonna do this im gonna do it right! Also i wanna kno has anyone tried Iv'ing it yet since they washed it?

I did once an IV session of acetone-washed blow. No problem. I suppose if it's for IV you would wait the full regular 12 hours (or is it 24?) for the acetone fully to evaporate before IVing it, although acetone is not very toxic, the body produces some in small quantities.

For cooking into crack I'm not sure drying it up more than a few hours is imperative, the acetone residues would vanish into the cooking water anyway.

By the way, I didn't notice any difference (with that one and same blow) between the following two alternatives:

1) IVing the blow direct
2) first cooking it into crack, then reacidifying it with ascorbic acid for injection.

Same effect, same strength. There was never any theoretical grounds for the two to differ anyway.

 

[Fight Club]

Alright even though i get some great coke here where i live (southern state) i figured i would give it a try and see what this is all about. Before i do that though i wanna kno what would be better?

A. just doing the acetone wash and letting it dry.

B. Doing the convert to freebase then do a/b conversion back to hcl.

IF im gonna do this im gonna do it right! Also i wanna kno has anyone tried Iv'ing it yet since they washed it? How was it let me kno or any other info you think i should kno. thanks in advance

Be careful if you are going to IV; pure cocaine HCL will dissolve at a rate of >1gram / CC water. Once you depress the plunger, you can't get it back out! If you are going to do this, start with a very small dose and dillute the HCL solution so you don't end up with a half gram pure coke in your veins when you push 50 units.

FC

 

[BlueEclipse]

I did once an IV session of acetone-washed blow. No problem. I suppose if it's for IV you would wait the full regular 12 hours (or is it 24?) for the acetone fully to evaporate before IVing it, although acetone is not very toxic, the body produces some in small quantities.

For cooking into crack I'm not sure drying it up more than a few hours is imperative, the acetone residues would vanish into the cooking water anyway.

By the way, I didn't notice any difference (with that one and same blow) between the following two alternatives:

1) IVing the blow direct
2) first cooking it into crack, then reacidifying it with ascorbic acid for injection.

Same effect, same strength. There was never any theoretical grounds for the two to differ anyway.

No i dont plan on turning it into crack and iv'ing it i plan on the amonia (sp?) way to convert to freebase not the cooking it way. wanting to convert it to freebase in hope to make it as pure as possible in hcl. but if doing that is not nessisary and jsut acetone washing it will make it jsut a good i wont waste the time.

I plan on letting it dry at least 48 hours at least. Also thanks for the warning about the water and how much coke can disolve in 1cc of water. i already knew it would be alot. but i always try and be careful by mixing it all up at once. i measure out and premix everything so im not trying to mix up anything to iv once i start so i dont add to much and have it let aside in a vile. so whenever i want some i just shake and measure up how much i want.

 

[Fight Club]

No i dont plan on turning it into crack and iv'ing it i plan on the amonia (sp?) way to convert to freebase not the cooking it way. wanting to convert it to freebase in hope to make it as pure as possible in hcl. but if doing that is not nessisary and jsut acetone washing it will make it jsut a good i wont waste the time.

I plan on letting it dry at least 48 hours at least. Also thanks for the warning about the water and how much coke can disolve in 1cc of water. i already knew it would be alot. but i always try and be careful by mixing it all up at once. i measure out and premix everything so im not trying to mix up anything to iv once i start so i dont add to much and have it let aside in a vile. so whenever i want some i just shake and measure up how much i want.

You sound so much like me in my early coke shooting days. You are probably thinking you won't get all fucked up in this because you purify, filter, pre-mix, measure, etc.

I don't know how long or how often you have done IV coke in the past, but, at the end of the day (if you are like me) you will end up a reckless fiending junky.

Be careful and good luck . . .

FC

 

[BlueEclipse]

i just wanna kno if it will make it any stronger for iv'ing or just a waste of my time.

 

[xxl]

i just wanna kno if it will make it any stronger for iv'ing or just a waste of my time.

If your resources and time are limited, investing in a micronfilter will be more profitable in terms of safety.

I never did an a/b extraction, or what I did was wash with acetone, then cook the blow into crack (baking soda method, or "ghetto method" to use Le Junk's phrase). Then I reacidified it with ascorbic acid. You could call it a crude a/b extraction. But I noticed the acetone wash had already removes whatever removable impurities it contained, so I later skipped the crack+reacidification step. My blow probably contained no active adulterants. The acetone removed 10% of the weight, most probably inactive stuff. Still, for IVing even non active stuff is undesirable.

Note that purification never makes blow "stronger". It makes it purer. In fact if it contained speed (a "strong" stuff!) and you remove the speed, your blow will be weaker in terms of strength. But of course it will be better.

For IVing purification should be mostly about making it purer with safety in mind (= remove the shit that can be hasardous).

 

[BlueEclipse]

thank you xxl. so i guess purification is really if you coke is cut with alot of junk and you plan on snorting it.
I prolly still give the purification a try sometime next week and compare.

 

[Dtergent]

Wow... great information. Thanks!