• Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Cocaine Le Junk's Cocaine Purification Megathread v. The Final Word

yep, no way you will get anhydrous OTC.......

you could always make it pretty close to anhydrous with baked(dry) magnesium sulfate
(epsom will leach water from the acetone)
 
It means water dissolves in acetone. It's a property of the chemical. The idea is to have acetone with very little water dissolved in it, because cocaine hcl is soluble in water but not in acetone.
 
If the problem is removing the little amount of plastic that has been dissolved just make a reflux condenser with some water, 2 glass bowls, and 2 pots.

Place a small glass bowl with a mouth equally as large as the base of the other bowl. Put the acetone in the pot. Place the large bowl on the pot so that it rests on the rim of the pot like a lid. Put the assembled reflux condenser into another larger pot. Add water to the larger pot so that it is about 1" from the top. Add ice water to the big bowl and then apply low heat to the bottom using an electric range.

While it is distilling it needs constant supervision, it is a basically a bomb on a stove after all! Remove water and add ice as needed. Keep a constant eye on the temperature and idle it between 50-55 deg C NO HIGHER, the bp for acetone at STP is about 56 deg C. Remove the whole system from the heating element if the temp seems to climb uncontrollably. Be patient above all.
 
hussness said:
It means water dissolves in acetone. It's a property of the chemical. The idea is to have acetone with very little water dissolved in it, because cocaine hcl is soluble in water but not in acetone.


^^^Exactly what he said!

Le Junk ;)
 
I was going to try this method but was told that hydrocloric acid is deadly shit and can get left behind. Is this true? And if this sounds stupid I might have taken 1 valium too many :)
 
I'm going to merge this with the cocaine purification thread because that is really where it belongs since this info is relevant to that thread.

<-> Merged
 
Seperating Epsom Salts (Magnesium Sulphate) from Acetone

I have no glass pipette, and can't seem to get a hold of one, I might order one.

But I was thinking that I might be able to run the Acetone + Epsom mix through a coffee filter and be left with anhydrated acetone. If I did it quick enough the acetone would not be able to suck up much water.

I don't see why that wouldn't work, but then again, I'm not a chemist.
 
my first post in my favorite thread..

a tip:

If you have to use epsom salts to get your acetone to 99-100% then measure out a small amount more than what is required for the amount of cola you are purifying, then put the epsom salt in it..that way it will absorb all the water \shit a lot quicker incase your impatient.
 
kizm0 said:
my first post in my favorite thread..

a tip:

If you have to use epsom salts to get your acetone to 99-100% then measure out a small amount more than what is required for the amount of cola you are purifying, then put the epsom salt in it..that way it will absorb all the water \shit a lot quicker incase your impatient.

You should have first probably said, "after the epsom salts are baked for 2 hours at 400 degree F.", thus producing your anhydrous magnesium sulphate. Otherwise, one might be led to think he actually just adds the epsom salts, as is. Just a thought, but welcome to Bluelight and thanks for making my thread your first post! ;)

Le Junk =D
 
Regarding the look and feel of the epsom.
I baked mine at 250 degrees C for 2 hours.
It came out a bit whiter than it went in.
When added to the acetone it didn't do much.
Just lying at the bottom, looking a lot like it did before I put it in the acetone.

Also, filtering the whole lot to leave only dry acetone, would that be possible?
 
sparrows said:
Regarding the look and feel of the epsom.
I baked mine at 250 degrees C for 2 hours.
It came out a bit whiter than it went in.
When added to the acetone it didn't do much.
Just lying at the bottom, looking a lot like it did before I put it in the acetone.

Also, filtering the whole lot to leave only dry acetone, would that be possible?


You need to crush up the dried epsom salts (now anhydrous magnesium sulphate) into a powder before adding it to the acetone. Did you do that first? If not, please extract that anydrous magnesium sulphate pop-sickle out of your acetone and start over with some new epsom salts. This time, when your done baking them, make sure you crush it into a powder first, okay?

Le Junk ;)
 
something ive always wondered which im sure is a simple answer,

it seems that each purification method is based on one thing, knowing what your cocaine is cut with.

the people i would get it from, arent, and probably coudnt if they wanted too, tell me what the coke im buying from them is cut with.

which method would u propose using if u dont know the cut le junk?
 
The standard methods that were explained will remove a good amount of the stuff...no one is going to be able to tell you everything that was added in, as it has probably been cut with something new every time it passed into someone's hands since it came over the border. And no, they don't cut it on the other side..most of the shit gets added once its here in the country. Simple economics, better to sell the good stuff at a higher price, while incurring less risk/cost of transportation to move a smaller amount of product over the border. If you're shipping dozens of kilos, those cuts would add a LOT of weight to that shipment, and is not worth it. Most of the shit added is by the smaller dealers, and nearly all of it once it makes its way over the line.
 
Ruined Acetone?

Hi there, I must first say thanks for this procedure, I am in the UK and cannot wait to try it out!

However I purchased a litre of 99.5% acetone in december time that has been stored in the garage, I have unscrewed the cap a few times and used a small amount of it for other purposes, though the other day I noticed the cap wasn't properly done up.

I need to know if this acetone is still any good or not?!? I added roughly 5-6g of dry epsom salts to it, should I add say another 10-15 grams (or more) if that will make it anhydrous again?

Thanks
 
fungus amongus said:
Hi there, I must first say thanks for this procedure, I am in the UK and cannot wait to try it out!

However I purchased a litre of 99.5% acetone in december time that has been stored in the garage, I have unscrewed the cap a few times and used a small amount of it for other purposes, though the other day I noticed the cap wasn't properly done up.

I need to know if this acetone is still any good or not?!? I added roughly 5-6g of dry epsom salts to it, should I add say another 10-15 grams (or more) if that will make it anhydrous again?

Thanks

When you say dry epsom salts, you do mean baked epsom salts at 400 degrees F. for 2 hours first, epsom salts, didn't you? If that's the case, then yes, adding another 10-15 grams of thoroughly crushed up anhydrous magnesium sulphate (formerly epsom salt) would be fine and recommended.

Keep us posted as to the results, won't you?

Le Junk ;)
 
Le Junk said:
When you say dry epsom salts, you do mean baked epsom salts at 400 degrees F. for 2 hours first, epsom salts, didn't you? If that's the case, then yes, adding another 10-15 grams of thoroughly crushed up anhydrous magnesium sulphate (formerly epsom salt) would be fine and recommended.

Keep us posted as to the results, won't you?

Le Junk ;)
Sweeet! I baked the epsom salts in the oven at gas mark 7 for just over 2 hours. I hope that is sufficient! I will be trying the wash on saturday hopefully, fingers crossed for the results!
 
Tried to do some searching to no avail.

1) Can I use the handle part of a spoon for the stirring, instead of a glass rod?

2) I'm thinking it would be better to use "100% Acetone" w/ Denatonium Benzoate/Bittrex rather than buying 98% acetone at Home Depot and messing up the "epsom salt" part (yes, i'm being a bit lazy). From the few posts I read on bittrex it seems that it doesn't butcher the washed coke in terms of taste. Is this correct?

Help with these questions is greatly appreciated.
 
Last edited:
i found some Acetone at a local store, its from a company called Sunnyside and I actually found a website which lists it http://www.sunnysidecorp.com/clean_epoxy.htm
so would this "100% water miscible" acetone work without having to do the Epsom method. if not would anyone happen to recommend a brand? NOT an online retailer just the brand.

thank you.
 
darkhamsterlord said:
i found some Acetone ... http://www.sunnysidecorp.com/clean_epoxy.htm
so would this "100% water miscible" acetone work without having to do the Epsom method.
I don't think so. Miscible means you can mix in in all proportions with water, which is what you don't want to do (and what, alas, this provider may have done to have the right to sell it uncontrolled). Pure acetone is now restricted. Or maybe this provider is selling pure acetone, and is hinting at the purity by adding the line about it being miscible, it is not possible to tell from the site.

Note that methyl ethyl ketone (the other product on this site) is also on the list of DEA restricted solvents. I think its properties are identical to acetone and if you can find it pure, it can be used for identical purposes.
 
It's true: the kick from unwashed / unrefined street grade cocaine (here in northern germany) is impertinent. It's a sickening, sore, anti-cocain, flash-of-fear-run-to-emergency-admission kick. The small amount of cocaine contained (up to 10 % as I must experience here) is thus made use- and worthless.

Oh how i hate those pushers, how I hate society and politics for torturing me with that criminal scum by their impertinent laws.

I want pure 100 % cocaine hydrochlorid for 50 € / 10 grams. That should be normal.

F***k them. F***k them all.
 
Top