L/J, You are my new Hero!
Here is crack-to-coke conversion, as described by Le Junk.
It works!
I've seen it done, and I would not post such an endorsement without being able to confirm it.
--------------------------------------------
Okay, dissolve one gram of rock in 10 ml.s of anhydrous acetone. Stir until all is dissolved. Filter into a sperate beaker to form a clear liquid. Once the 10 ml.s has drained thru, pour 10 more ml.s of fresh anhydrous acetone into the filter trying to cover all the area the first acetone did. This will assure you've got all the dissolved freebase in your new beaker, now with 20 ml.s of acetone and your 1 gram of dissolved freebase. Make the necessary adjustments for more freebase with the acetone. It's always 10 ml.s at first per gram, filter, and follow with 10 more fresh ml.s.
With your dissolved gram of freebase and 20 ml.s of acetone, use a glass eye dropper and add 10 drops of 31% muriatic acid to the beaker. Stir for a second until crystals start to form, and let the acid do the rest. Let sit for about half and hour. Stir again, making sure you really get the bottom of the beaker where the freebase like to collect. Wait another half an hour. Stir again, if any new crystal growth forms, wait again and so on until no more crystals form.
Now, pour your newly formed cocaine hydrochloride crystals into a clean beaker thru a new filter. Let drain thoroughly and then remove filter from funnel. Press firly between a few paper towels on the coke clump while still inside the paper towels until it's dry.
Place the filter still containing the crystals under a heat lamp until the paper is dry.
Pour out onto a plate and place the crystals directly under a heat lamp to dry any excess moisture.
Now, your cocaine is clean, but is snortable cocaine.
Now, just go about your usual method for turning powder into rock.
That's it.
Okay, a couple important factors I need to mention that I didn't send you because I was all jacked up when I sent it to you. And ironically, as you'll see from my rather lengthy reply this time, I am again!
okay, it is EXTREMELY important for you to do all of the following, no substitutions or alterations either, okay:
1. Your acetone must be completely or damn near anhydrous (absolutely NO water or alcohol in it at all!). If you don't have chemical company acetone, then use the epsom salt and home store acetone method to make your home store acetone anhydrous. In fact, it's probably just as good a method or better than the chem. co. stuff. Buy a 1 liter can of acetone a Home Depot or Lowes. Also buy a bag of epsom salt. Preheat your oven to 400 degrees. Place about a cup of epsom salt, spread out over a sheet of aluminum foil placed over a baking pan. Cook for approx. 1 1/2 to 2 hours until it's turned into a greyish ash. At least 1 1/2 hours, though. Now, pour about 10 grams of the greyish ash (formerly the epsom salt, now anhydrous magnesium sulphate) directly into the 1 liter can of acetone. Shake vigorously for about 1 minute. Let stand steady for 24 hours. Your can of store bought aceone is now anhydrous. But be careful, your clump of goo, now at the bottom of the can is the water and alcohol that the magnesium sulphate absorbed. So therefore, when using the acetone from now on, you don't want to pour it out, but rather use a glass eye dropper to pull out the amount of acetone you plan on using. I'd just go to CVS or Walgreens and ask them where their glass eye droppers are at. They usually come in a pack of two and are very cheap. Important: they have to be glass and not plastic. Plastic will dissolve in acetone. Simply squeeze the top of the eye dropper and then stick it into the acetone can about 3 inches. Let go of the top and pull out as much acetone as you can into the eye dropper. Repeat as many times as necessary to get what you need. As the can get's lower and lower on acetone, just carefully tilt it to get the acetone near the top. When your down to about a 1/2 a can, just throw it away and make a new one.
2. Your freebase should be crushed up and COMPLETELY dry before adding it to acetone. If your freebase is the yellowish/gold crap that never really dries completely, but stays kinda moist feeling, then there's alot of benzocaine or procaine in it as well. You really need to crush this crap up as tiny as you can and let it dry as much as you can first before ever adding it to the acetone. The reason being that the moistness is water, and water is the enemy when it comes to creatinging HCL. Did you kinow that it only takes 1/2 ml. of water to dissolve an entire gram of pure cocaine HCL? So in other words, do your best to get it dry. Hopefully, you'll have the bleach white freebase that hardens like rock and this won't even be an issue.
3. When doing an A/B extraction (which is what your doing), the first batch is always the best and most euphoric, followed by the second, then third and so on. Therefore, instead of adding 8-10 drops all at once, you can do it in increments. Personally, I do 3 drops of acid per run, let it completely recrystalize until finished, and then filter the remaining active freebase/acetone into a seperate beaker. Then, repeat with 3 more drops, recrystallize, and then filter into a seperate beaker and so on. You'll find the first batch INCREDIBLE, the second batch great, the third batch okay, and then you'll probably be done. Once the addition of acid produces no more crystals, you've got your entire gram back. Note: near the 3rd run, I'd drop back to just 2 drops of acid instead of 3. This is because your nearing the end of your gram and there is no way to judge when 1 more drop will be to much, so drop back to 2 at a time after the second run.
4. Each time you remove the filter, carefully open it and let it air dry for a few minutes before letting it fall out onto the plate. You'll also notice that the first batch will look better than the second batch and so on and so on. Once the filter paper is dry, let the largest clump fall out onto the plate. Then carefully close the filter paper in half and gently rub it back and forth in your hands over the plate to let any additional fall out. Anything else that's stuck to the paper, use a non-serated knife to scrape it off.
Damn, I'm just freakin' ramblin and ramblin' on. It's important info, but you'd think you were family or something. Damn this blows good!
good luck, Le Junk
Your fine near or at sea level as long as the A.C. is on, and kept on. Also, try and cover your beaker with a small saucer while the crystals are forming. Basically, as soon as crystals start to form, cover the beaker immediately.
The 31% muriatic acid is what is suggested in my "Cocaine Handbook", and that book has always been refered to as "the" bible of cocaine by even the chem. pro's. So, don't worry about what the additional ingredients are, some of which is water. Don't ask why, just do it. It works.....................GUARANTEED!
How do I know? Well, I do it all the time, so that's why it comes with a guarantee! Like I said, do 3 drops on your first run, and 3 on the second. 2 on the third and maybe 4th if you still have any active freebase left.
Oh yeah, I forgot one VERY important thing. If you have a friend there to help you, that would be great. The reason being that in a perfect A/B extraction, the acetone/freebase should be stirred and still swirling when you add the acid. It's extremely important to stir the bottom, because that's where all of the freebase lays, even though you can't see it. So, by stirring the beaker just prior to ading the acid, you get it up and moving which is what you want.
After 1/2 an hour, make sure you really stir the entire bottom of the beaker. You'll also notice that when you first add the acid, that when the first crystals start to form, that the bottom gets very sticky. That's the freebase, and you need to go back and forth over the entire bottom to get it into the acid.
To see if the recrystallization is complete after 1/2 an hour, stir thoroughly and then run the stir stick up the side of the beaker above the acetone level. if new crystal growth forms on the edge of the glass, it's not complete, so cover and let sit some more. Repeat until done.
Good luck bro. Keep me posted.
----------------------------------------------------
Tremendous information, and very useful for those who wish to use safely.
Thanks, Le Junk
Now, I go forth, to spread the gospel according to Le Junk.
Oh, ...one more thing,
You can use small preserve jars (used to make jams & jellies) as containers to hold the acetone mix, just be aware that when converting back into HCL you can let the thing settle for a few hours after adding the acid drops. The cloudy mixture will settle into coke, but it will stick to the side of the jar so you will have to empty the acetone, scrape coke off the side of the jar. It's better than standing there stirring the damn thing for 2 hours.
Pablo
