• 🇳🇿 🇲🇲 🇯🇵 🇨🇳 🇦🇺 🇦🇶 🇮🇳
    Australian & Asian
    Drug Discussion

    Welcome Guest!
    Posting Rules Bluelight Rules
  • AADD Moderators: Tronica

Urgent: How to make speed smokeable after uve bought it..

Status
Not open for further replies.
N

natha323323

Greenlighter
Joined
Aug 20, 2011
Messages
3
I buy from same person. Sometimes smokes up nice, other times (like what I just bought), it just blackens on the bottom of pipe & tastes terrible, then have to swallow it.

I have been looking forward to smoking all week, and this stuff doesnt smoke up. Can i add/do anything to it to make it smokeable? Smoking partner is coming over in 90 minutes and i want to get sorted by then...
 
Do an anhydrous acetone clean on it. Search BL and you will find a method on how to do it. The acetone needs to be completely free of water, and may require the use of baked epsom salts to remove any moisture in it.

Unless you have acetone and magnesium sulfate on hand, or can go to a hardware store it's probably not going to happen in the next hour and a half.
 
far out ok read it all, seems like a bit of a mission but maybe.. will kmart have acetone and magnesium sulfate?
 
and i guess first question should be, im only talking about 6 points, will i get all that back with an acetone bought on the cheap (ie preumably with some water in it)?
 
You will lose weight because you are losing the cutter. And expect there to be some loss as well; I was once advised by a clandestine chemist that if you are doing it at home in amateur conditions, expect a 5% loss at each step (he wasn't talking specifically more about this procedure, more about clandestine chemistry in general).
 
When washing such small quantities, I've found the loss to be very minimal and not necessary to go through the steps of turing into anhydrous acetone unless you're really fussy. I just use store bough acetone which is usually 99%(make sure you check the labeling), put whatever you're washing inside the filter and just dump the acetone over it to minimize losses. Just make sure you let it air dry for at least 24hrs before putting it through the pipe because the taste of acetone is fucked!
 
^ If you are using a newly opened bottle of acetone then it is fine to skip the anhydrous process, but acetone that has been used before or left exposed before could have enough water in it to cause losses.

And alternatively to waiting for it to dry for a day, you could gently heat it. The boiling point of acetone is relatively low compared to water, and much lower then that of methamphetamine.
 
Lesson learned here is :

Know your substance, Know your source. BUY from trusted source only.

ANd buy quality product only ^^

If it blackens, i'd say he's cutting it with glucose of some sort. Does it smells like caramel inside the pipe after its blackened???

If so i'd take it back and be like YO man stopp cutting my cutted gear with sugar HOMIE!
 
Status
Not open for further replies.
Top