• CD Moderators: someguyontheinternet
  • Cannabis Discussion Welcome Guest
    Posting Rules Bluelight Rules

thin layer of tape on block of hash

generally the hash round these parts is black or a greenish hued roll - But sometimes you can get lucky and find pure hash oil

The better stuff is naturally oily I found, but they all needed a tiny bit of heat to crumble up

I find when heat is added it helps soften the hash and you can just crumble it into small oily peices to lay out...
Normally its just you take a lighter, skim it over the hash and apply some heat, not to the point where it smokes and burns, but just enuogh to soften it...

This aint the case with hash made from pure Keif from dried budd, but its usually the case with middle-eastern type hashes made by hand... Just the quality varies by place of origin...
 
Middle eastern hashes are made from sieved resin glands, i.e. kief. If what you are referring to is hand-rubbed hash, that is typically from the Indian subcontinent (where humidity is too high for sieving).

As has been said before, you do not need to take a lighter to good hash. Even Moroccan that is very hard at room temperature can be broken up for smoking with your hands alone.
 
I'm from England n I've got some nice affy black in soft enuff to just roll but def a beter smoke when burned n crumbled any1 no y?

Soap bar is utter nastyness u find the tape burnin q hole in ur bedding from the spliff. Also I've always if the hash gives a nice clear white smoke when burnt good indicator
 
I'm from England n I've got some nice affy black in soft enuff to just roll but def a beter smoke when burned n crumbled any1 no y?

Soap bar is utter nastyness u find the tape burnin q hole in ur bedding from the spliff. Also I've always if the hash gives a nice clear white smoke when burnt good indicator
 
Purifying soapbar with boiling water will get only some of the crap out - it's not really a complete method, but i'm sure it would help
I'd do that to get the non-polar stuff out, then dry the product, and dissolve in 91% IPA (really, where are you going to get 99%? And 91% is known effective for dissolving cannabinoids, and will be less effective at dissolving other stuff than 99%), filter out the insoluble crap, and then evaporate the IPA to get something less-filthy than the soapbar.
 
TheAzo said:
Purifying soapbar with boiling water will get only some of the crap out - it's not really a complete method, but i'm sure it would help
I'd do that to get the non-polar stuff out, then dry the product, and dissolve in 91% IPA (really, where are you going to get 99%? And 91% is known effective for dissolving cannabinoids, and will be less effective at dissolving other stuff than 99%), filter out the insoluble crap, and then evaporate the IPA to get something less-filthy than the soapbar.
Click to expand...

safeway...
 
You must log in or register to reply here.
Top