• 🇬🇧󠁿 🇸🇪 🇿🇦 🇮🇪 🇬🇭 🇩🇪 🇪🇺
    European & African
    Drug Discussion


    Welcome Guest!
    Posting Rules Bluelight Rules
  • EADD Moderators: Pissed_and_messed | Shinji Ikari

The I'm Fucked Megathread: Running out in limbo land

Status
Not open for further replies.
Seems I've got through a quarter of drone since about mid day yesterday. What the fuck. I've worked both days. Where the fuck has it all gone.
 
Had a nice day with a few beers, just swallowed a free "Fury X" "Pellet". Smelt of aMT and tasted of x-APB.

I hope this is fun.

At least I have weed and etizolam if things go tits to the breeze.

Fucking onwaaaaaaads
 
Lucky Cornishfiend4! 100mg I M is enough for a nice hit. How do you I M crystal? Like what is the process? Can you just chuck it in water or do you need other stuff? I could never hole properly off kmax vials unless I I M'd 2ml in each leg a few times. Crystal you could dose accordingly like 150mg a ml or something. Proper clean hole I bet :D
 
100mgs(ish) of dissolved ketamine crystal sat ready infront of me. Ready to be administered.

Can't decide whether to IV or IM?

Hmm....

EDIT: IM'd a good un.

I seem to remember Shambles saying he had better luck with IM than IV when his tolerance was sky high? 93% IM bioavailability can't be sneezed at anyway. Hmmm, I'd like some ket. This 2-MeO-Ketamine better be good. It'll fly off the shelves.
 
Lucky Cornishfiend4! 100mg I M is enough for a nice hit. How do you I M crystal? Like what is the process? Can you just chuck it in water or do you need other stuff? I could never hole properly off kmax vials unless I I M'd 2ml in each leg a few times. Crystal you could dose accordingly like 150mg a ml or something. Proper clean hole I bet :D

Firstly, I get those lil spoons from the needle exchange v similar looking to this.

3_206193570.jpg


And squirt about 0.7ml pre boiled/sterile water into it.
Then I add the K and I give it a shake and a lil bit of heat to get the crystals to dissolve.
Normally I wouldn't preach such advice, but the K around here is uncut pure.

& warm/hot water is a much better solvent than cold water so it saves time. (once again. I only ever do this with K).
I know this goes against HR, but once the solution is prepped, I just remove the pin from the barrell and suck up the solution without even using a filter.

This may sound like utter madness, but I've seen this particular ketamine crystallized infront of me from a sterile vial and I know 100% that there's zero cut in it.

Hence there being no point in filtering.

Then I let it cool for a couple mins and IM away! Tried and tested many a time.....

I seem to remember Shambles saying he had better luck with IM than IV when his tolerance was sky high? 93% IM bioavailability can't be sneezed at anyway. Hmmm, I'd like some ket. This 2-MeO-Ketamine better be good. It'll fly off the shelves.

Yeah, it's deffo better than snorting.

Feels much the same but with no snotty shite. Plus the K goes miles further....
Makes me wonder why peeps are so anti needle?
 
I'm almost moist at the thought of that. Your under dosing it though, 250mg I M would be just perfect, especially at this hour, tunes and headphones in, trippy movie on lay back in bed and let the hole do it's thing.

What brand of vials did it come from?

Yeah hot water be perfect I suppose if you know it came from sterile vials. Could you not just use a teaspoon to put the water in?

I far preferred I Ming vials to drying them out and crystallising. So much cleaner. Just a nuisance to hole cos of the stupid 50mg/ml concentration.
 
Then I add the K and I give it a shake and a lil bit of heat to get the crystals to dissolve.
Normally I wouldn't preach such advice, but the K around here is uncut pure.

& warm/hot water is a much better solvent than cold water so it saves time. (once again. I only ever do this with K).

I'm not sure what your "normally wouldn't", "only ever do this with K" is about. Are you against using heat for injecting generally? I've only IM'd drugs a couple of times, but whenever I plug anything I pop the solution in the microwave for a couple of seconds, always makes the dissolving easier.

EDIT: Reading rockstar's post, I'm thinking the concern about heat is encouraging bacterial growth, is that right? Do the fuckers really breed that fast?
 
Last edited:
I'm almost moist at the thought of that. Your under dosing it though, 250mg I M would be just perfect, especially at this hour, tunes and headphones in, trippy movie on lay back in bed and let the hole do it's thing.

What brand of vials did it come from?

Yeah hot water be perfect I suppose if you know it came from sterile vials. Could you not just use a teaspoon to put the water in?

I far preferred I Ming vials to drying them out and crystallising. So much cleaner. Just a nuisance to hole cos of the stupid 50mg/ml concentration.

Lol, if I didn't have folks sleeping beneath me right now or I'd be doing 200mgs+ for sure.

I'm tempted to go for a nice trip/hit......

The vials are the ketamax variety.

A teaspoon will be spot on.
I just prefer the needle exchange spoons and pins cause of the quality/cleanliness, ease of use & being disposable. (I'm a drug snob!)
 
I'm not sure what your "normally wouldn't", "only ever do this with K" is about. Are you against using heat for injecting generally? I've only IM'd drugs a couple of times, but whenever I plug anything I pop the solution in the microwave for a couple of seconds, always makes the dissolving easier.

EDIT: Reading rockstar's post, I'm thinking the concern about heat is encouraging bacterial growth, is that right? Do the fuckers really breed that fast?

I don't think bacteria grows that fast. With any street drugs it's advisable not to heat prior to injection.

Namely cause the hot water solvent will help dissolve nasty cuts.
EDIT: I'm mainly talking cocaine here. Under no circumstances should anyone apply heat to cocaine hcl for IV use.
 
^ indeed, also tolerance builds really fast for the NBOMes, you had some not that long ago didn't you?
 
Status
Not open for further replies.
Top