starter at muscle building, wat type off steroid should i try and aquire?

I'm not saying it's impossible to make, I'd just imagine it to be really unpleasant and painful to inject. Imagine the crystals that might form as the solvent dissapates lol. Ouch!

What's the highest strength you think is legit that you've seen on the market Mike?
 
I'd be dubious GF. I expect mixing esters should probably slightly reduce crystal formation. But holding it all (esp if shorter esters are involved) in solution at 450 means lots of solvent and not much oil. So nothing very lipophilic for the esters to embed within, meaning both (a) relatively rapid release profile and (b) lots of irritation and PIP around the muscle. Once you go over 350, in my experience (but maybe not others) generally it becomes painful even with stuff like benzyl salicylate. And not many UGLs are going to use expensive stuff like that to reduce pain. I'll happily stand corrected on all this though.
 
CFC said:
I'd be dubious GF. I expect mixing esters should probably slightly reduce crystal formation. But holding it all (esp if shorter esters are involved) in solution at 450 means lots of solvent and not much oil. So nothing very lipophilic for the esters to embed within, meaning both (a) relatively rapid release profile and (b) lots of irritation and PIP around the muscle. Once you go over 350, in my experience (but maybe not others) generally it becomes painful even with stuff like benzyl salicylate. And not many UGLs are going to use expensive stuff like that to reduce pain. I'll happily stand corrected on all this though.
Click to expand...

That might be the difference i missed out.
The person makes certain things upon request as long as its worth the while and he deals with a lot of high level athletes in general not just body builders. So that might be the case
 
I could believe that. It wouldn't be economical to make for widespread distribution since you're competing against a whole load of other UGLs and people generally just go on price. But for special orders (and if you're prepared to suffer some PIP annoyances and use larger needles and heat to reduce viscosity) you could achieve a very high dose.
 
I've injected 500mg test per mL but it was in guaiacol. Shit made me stink, and the pip was unbearable due to the high alcohol content. I had a tennis ball sized lump on my glute after that. What's weird is some of the other guys had no problems whatsoever with it. Never again, there's no reason for it really. If I get any test that's over 250mg/ml then I always end up cutting it with sterile GSO anyway. But that's my preference.
 
I found my breath stank of guaiacol lol. Yeah, I can't see any reason for ridiculously concentrated AAS unless you're a pro stepping on stage putting in 50+ml of AAS a day really.
 
You must log in or register to reply here.
Top