• BASIC DRUG
    DISCUSSION
    Welcome to Bluelight!
    Posting Rules Bluelight Rules
    Benzo Chart Opioids Chart
    Drug Terms Need Help??
    Drugs 101 Brain & Addiction
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums
  • BDD Moderators: Keif’ Richards

Removing Binder/Filler From Oxycodone 30mg

Itsfuntolose

Greenlighter
Joined
Jan 23, 2012
Messages
3
Good day everyone,

I go on a little pill binge now and again. Usually will end up with 20 30MG Oxycodones that I go through in 10 days then clean for about 3 months repeat. I have used the search engine to try and find a method to do this but have not had much luck except prep for injection. I am trying to find a way to remove the binder/filler from the oxycodone. My personal favorite ROA happens to be vap'ing the blue babies on the duller side of a piece of foil. I know it is bad for me (which is why im asking if there is a way to reduce risk) and I would like to get that out of the way now before there are a bunch of posts saying that. As for it being wasteful i find it to be the best for me, I dont "slam" and wont. I'm not scared of it but i know i would enjoy it too much (its not addictive cause it sucks). When I get warm and fuzzy for work, I drink 2 cups of White Grapefruit Juice about 1 hr before use, then take 2mg alp for potentiation. I also take antacids 10 minutes before, right before, and after my use (I do not ride dirty so I get my fix as best I can before work) I typically break the pill into four pieces. I snort a 1/4, drink a 1/4 that has been crushed and dissolved in a small amount of water, I take the other 1/4 as is without crushing, and then to my favorite part. I take a hose clamp and mill the remaining 1/4 on the dull piece of foil that I have flattened and taken all the creases out. I make the lines long and thin. I know too much heat will destroy the blues love so I keep the flame as far away from the foil as possible but because the powder is so fine I do not have to apply much heat and I can get many small hits that I can hold in using a bic pen to inhale the smoke with. When I dont have to work I always smoke them (that works best for me) I will be scratching my face off after about 3/4 of a blue . I enjoy the taste, shaving the pill, the whole process is addictive for me. I am wondering if there is a simple way to remove the filler from the blue and just keep her love. Will a CWE remove the filler/binder? Acetone (that one im concerned about because even if i evap im worred about smoking acetone)? Basically I would like to enjoy my lady without dealing with her shitty friends.

Regards,
Itchy Face

P.S.
I know a lot of people think it is a waste to smoke but it is what i prefer. Im just trying to find make it safer.
 
If you find a FULL ingredient list (active and inactive), then you can find a solute that will dissolve the opioid and leave behind all the other stuff. Once you've created this solution, evaporate it. What is left will be a crystalline bit of pure oxycodone, which should be ~30mg for a single pill. More, and you still have a binder present or it's not fully evaporated. Less and you lost some to the process (which is bound to happen to a small degree).
 
Oxycodone is watersoluable.. theoretically you could filter the solution (preferebly wheel filter/micron), then evaporate the solution you have left and end up wtih a pure oxycodoen powder.
 
Cant seem to find a full ingredients list. I know Oxycodone is ws but aren't some of the binders/fillers as well? Mostly what im concerned about is that im trying to reduce the risk of harm/damage to my lungs by removing the fillers/binders, however, I do not want to smoke any type of solut even if i evap i think smoking a small amount of solut would be much more dangerous than the fillers/binders which are mostly talc.
 
Top