SpecialK_
Bluelighter
- Joined
- Mar 11, 2010
- Messages
- 3,531
Best of luck, BCF!
What a dreary day this has been so far, and I can't believe it's only Tuesday.
Even worse, I have some 25I-NBOMe to try and so the weekend seems even further away. Though it may take the best part of a week just to go about finding the cheapest, most efficient, yet most HR-friendly way to administer the stuff. The crystals are so tiny that 10mg of it looks a lot less than an equal amount of, say, 2C-B.
Obviously liquid measurement is going to be required, but I'm then planning to use a metered nasal spray bottle to dispense it. Does anyone have any tips / experience to pass on with regard to this? Obviously I'm reading the Megathread in PD, but as always I thought I'd check here too.
I had 25C-NBOME and as I only had a small amount (less than 20-40 doses) I just added it to some distilled water. I used the ratio of about 5ml per 500ug dose. This was fine for sniffing but I would advise trying to go a little smaller. I suspect 3-4ml would be much better without getting ridiculously precise but enough to prevent a drip. I just bought a wee vial, added it in (dissolved really easily, applied gentle heat just to make sure but you don't want too much and not for long - if you can wait just wait) then just used an oral syringe for dosing. It is quite easy to work with, provided you're careful and know roughly what you're doing. I wouldn't try and make it 'drops' or a say 2-3 drops in case the liquid you use evaporates, there's been a few overdoses due to that already.

