• BASIC DRUG
    DISCUSSION
    Welcome to Bluelight!
    Posting Rules Bluelight Rules
    Benzo Chart Opioids Chart
    Drug Terms Need Help??
    Drugs 101 Brain & Addiction
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums
  • BDD Moderators: Keif’ Richards

Quick question regarding meth

TweakTheSky

Greenlighter
Joined
Sep 29, 2012
Messages
4
Hey bluelighters, I am smoking Meth out of a automabile break light, light bulb lol. I want to know why at first I was getting decent hits, but now the meth doesnt really slide or create very much smoke. I am using a small amount of dope, could that be it? I am decent with not getting it too hot and whatnot. Any advice or tips would be great, been at this over a year now but always open to learning more. (:

Moderator Note: Welcome to Bluelight. Please don't use "SWIM" or any other variant as it makes posts hard to read, and offers no protection from legal ramifications.
 
Last edited by a moderator:
I dont know anything about smoking meth but i know those bulbs are pretty small maybe thats why, it could be covered in meth residue all over now.
 
it smokes up nice if you do it right, its all technique. try getting a meth pipe and using that. Melt it down and then swirl it around. dont get the shit so hot it burns you just want it to vaporize. if done right it should be fairly palatable and not harsh. i get huge clouds of fluffy white smoke when i hit a nice puddle in a meth pipe. oh when you load a bowl make sure its clean, like super clean. and melt the shit down into a puddle, let it crack back then melt and smoke again.
 
I've had no problems with a light bulb vape.
It's big enough you can always find a new spot, and clean meth shouldn't leave to much residue anyway if you do it right.
 
Since you're having trouble with this ROA perhaps consider looking into plugging, as it's considered to offer the best balance of efficiency, and relative safety.
 
im gonna agree with whats been said about the bulb - its likely caked with shit (cut n burnt product).

give 'er a clean n start again.

if it keeps fucking up then use a different route of administration such as plugging or oral use as bronson suggested.
 
Just a tip, if you can't get a real pipe instead of using a straw to smoke out of a bulb, you can use a mapp gas or propane torch to heat up a small spot on the side(really hot, glowing bright orange, but its thin glass so shouldn't take too long, and start heating slowly with a low bushy flame all around the spot you want to pop, then turn up the flame and if you don't have a tight jet just use the edge of the flame to heat the little spot you want to pop a hole in) and then blow into the bulb to pop a little hole in it so you can actually turn it on its side and put your moth where you busted out the bottom and hit it like a real pipe.
 
Just make a new one ?
Is there enough air to smoke ratio ?
I don't no how long your using it for but I never use one for longer then one night as it is a light bulb. Also don't get tempted to put more in there because your not getting enough smoke cause if it's the light bulb and it shatters you just got burns on your face and wasted some good ole meth.
Once me an 3 other people used one for 3 hours straight smoking up perfect then about .020 was packed in, light up smoked and boom the whole thing started getting cracks lucky it wasn't my rip and everything turned out ok
 
Since you're having trouble with this ROA perhaps consider looking into plugging, as it's considered to offer the best balance of efficiency, and relative safety.

Yep. And if you don't want to do that, just swallow it. It is surprisingly very effective that way, lasts a long time, and the comedown is not as harsh as smoking/snorting/shooting up
 
Top