Camel-Man
Greenlighter
Though not ideal to do, I'm a bit desparate and curious too and want to try to make a decent iv solution from the dissolved oxycodone tablets.
After much reading over the recent weeks, I used the discussion located here: http://www.bluelight.ru/vb/archive/index.php/t-529644.html as my primary guide for making an oxycodone solution for injection. Luckily, I have plenty of the 10-325 tablets to experiment with.
In each "trial", what follows is what I've done and the end result. Here goes:
1. Using the mortar and pestle I have, I've finely crushed five of the 10-325mg oxycodone tablets, practically turning them into dust.
2. Using 75 units of sterile saline solution per tablet to dissolve the dusted tablets in, I've added the 5 tablets to the total of 375 units of saline solution.
3. The resulting quantity of powder in the solution turns out rather pasty but there is definte liquid that can then be filtered for use. So, after gently mixing, I let the mix stand for a couple minutes.
4. Using a tightly rolled cotton bud as the initial filter to trap the major particulate matter and by using a new rig, I'm only able to suck-up about 225 units of somewhat cloudy solution.
5. For further Harm Reduction, I then re-filtered that solution using a micron-filter. Afterward, I had a about 175 units of clear solution.
6. I then got a completely new rig, loaded the roughly 175 units of solution in it and then after sterlizing the site, shot it slow-n-steady as usual.
End result: Nothing --- Didn't feel anything, nothing at all. I'm thnking either not much oxy was in the final solution, or my tolerance is pretty high or both. Does anyone else have experience along this path? Thanks in advance.
After much reading over the recent weeks, I used the discussion located here: http://www.bluelight.ru/vb/archive/index.php/t-529644.html as my primary guide for making an oxycodone solution for injection. Luckily, I have plenty of the 10-325 tablets to experiment with.
In each "trial", what follows is what I've done and the end result. Here goes:
1. Using the mortar and pestle I have, I've finely crushed five of the 10-325mg oxycodone tablets, practically turning them into dust.
2. Using 75 units of sterile saline solution per tablet to dissolve the dusted tablets in, I've added the 5 tablets to the total of 375 units of saline solution.
3. The resulting quantity of powder in the solution turns out rather pasty but there is definte liquid that can then be filtered for use. So, after gently mixing, I let the mix stand for a couple minutes.
4. Using a tightly rolled cotton bud as the initial filter to trap the major particulate matter and by using a new rig, I'm only able to suck-up about 225 units of somewhat cloudy solution.
5. For further Harm Reduction, I then re-filtered that solution using a micron-filter. Afterward, I had a about 175 units of clear solution.
6. I then got a completely new rig, loaded the roughly 175 units of solution in it and then after sterlizing the site, shot it slow-n-steady as usual.
End result: Nothing --- Didn't feel anything, nothing at all. I'm thnking either not much oxy was in the final solution, or my tolerance is pretty high or both. Does anyone else have experience along this path? Thanks in advance.
