For the sake of clearness and related information, I will copy a thread leaving only the relevant info.
I tried this 2 times... First time I left the boiling solution a bit too long withough watching it and all water evaporated, I readded 20ml of water and mixed it after scrapping the bottom, caffeine did precipitate after I cooled it down but solution tasted awfully bitter still and I didnt get a high that was relevant at all... Second time I did it properly, but ended up with ~40ml of liquid and tried plugging it... 4 10ml full oral seringe up my ass but I couldn't hold it for more than 5 minutes and ended up loosing 80% of it.
So what the fuck should I do If i have to plug a great quantity of liquid, and does his method really work? How do I know I'm not wasting all codeine when I heat the solution up?
1. Crush 50 pills (325mg Tylenol / 15mg Caffeine / 8mg Codeine) into a very fine powder and mix it with 400ml of cold tap water using a hand mixer
2. Put the mixture in the freezer for 10 minutes, mix again, put in back in the freezer for another 10 minutes and then take it out;
3. Filter using a tower/cloth (We will boil the mix later so APAP will be destroyed anyway)
4. Put the filtered solution in a regular cooking pan, rince the jar you used and put it back into the freezer, heat the solution at one number under your high/max until there is about approx 15ml left (Roughly 15% or less of the codeine will be damaged);
5. Pour 15 ml’s of cold tap water into the solution. You will notice the solution will turn pitch white. That’s the caffeine starting to precipitate;
6. Take the empty, cold jar/pot out of the freezer and pour the solution into it, tilt the jar so that the liquid goes into the narrowest corner and put it on the freezer in that tilted position for 10 minutes.
7. You will notice after several minutes as the solution gets very cold that there is a new solid white crystalized powder forming in the solution. After the right amount of time (This can vary allot, so check your solution every 2 minutes), you will have thick solid white crystalized powder in the bottom covered by an almost clear solution on top of it (this is the codeine). The white crystal powder is of course, the caffeine;
8. Once it looks like the caffeine is solid underneath the codeine clear liquid, pour the codeine in a regular wide glass;
9. After pouring the codeine into the glass, cover the glass with the same cloth/towel you used to filter the solution (assuming you rinsed it well and that it is still soaken wet). Pour 20ml’s of cold tap water into the jar/pot (*avoid* pouring the water *directly* onto the caffeine) and slowly make the water go over the remaining Caffeine that is stuck to your jar/pot, make the water run over the caffeine and around the whole jar/pot by moving it once or twice with your hand in a turning circular motion, and pour it onto the cloth/towel – into the glass, to recover any codeine stuck in the caffeine (some of the caffeine might get un-stuck and start floating into the water –This is why we use a cloth/towel to filter it);
I tried this 2 times... First time I left the boiling solution a bit too long withough watching it and all water evaporated, I readded 20ml of water and mixed it after scrapping the bottom, caffeine did precipitate after I cooled it down but solution tasted awfully bitter still and I didnt get a high that was relevant at all... Second time I did it properly, but ended up with ~40ml of liquid and tried plugging it... 4 10ml full oral seringe up my ass but I couldn't hold it for more than 5 minutes and ended up loosing 80% of it.
So what the fuck should I do If i have to plug a great quantity of liquid, and does his method really work? How do I know I'm not wasting all codeine when I heat the solution up?