Hello all.
Today I hit up buddy and went and got my junk. This is same homie who been workin with me for a while now with almost 0 problems.
So today I get my shit and prepare my 1st go. I notice as I put the water in the powder it turns all cloudy and shit. I have been mix it a little with the plunger before I add the heat. Sure enough after I add the heat (not even that much)
After cooking I stir up again and then go to draw it up. Before I sucked it up it was still cloudy!! So it still draws
Up but looks different and a lil cloudy...
Are there any ways I could do something different tl avoid the cloudy solution? I still get a proper shot it just looks odd.
Any way all help would greatly be appreciated. THANKS
Today I hit up buddy and went and got my junk. This is same homie who been workin with me for a while now with almost 0 problems.
So today I get my shit and prepare my 1st go. I notice as I put the water in the powder it turns all cloudy and shit. I have been mix it a little with the plunger before I add the heat. Sure enough after I add the heat (not even that much)
After cooking I stir up again and then go to draw it up. Before I sucked it up it was still cloudy!! So it still draws
Up but looks different and a lil cloudy...
Are there any ways I could do something different tl avoid the cloudy solution? I still get a proper shot it just looks odd.
Any way all help would greatly be appreciated. THANKS