Need help ASAP-25i-nbome freebase + vinager = visible particles?

[bayhead415]

I have added at least 1 ml to 15 mg of 25i-nbome... I am guessing it should all be dissolved, but I still see little white particles in the liquid. When it is dissolved will all the 25i-nbome disappear or will there be particles suspended in the liquid? Maybe they are impurities?

Edit: It is about 2.5 ml water and 1.5 ml vinegar and there is still white particles at the bottom? Is this normal?

 

[klondike_bar]

I have added at least 1 ml to 15 mg of 25i-nbome... I am guessing it should all be dissolved, but I still see little white particles in the liquid. When it is dissolved will all the 25i-nbome disappear or will there be particles suspended in the liquid? Maybe they are impurities?

Edit: It is about 2.5 ml water and 1.5 ml vinegar and there is still white particles at the bottom? Is this normal?

its possible that there is a slight amount of nbome that either failed to dissolve in solution, or is simply not nbome (ie: your powder may be 97% purity, with 3% being insoluble)

a 4mg/mL solution shouldnt be difficult to dissolve. try adding some heat to warm the solution, and then stir for another 5min. sometimes it can take a while to really form a good solution with this stuff.

 

[IamMe90]

I've always found heat and motion absolutely necessary to fully dissolve all of the residual granules of powder, even at pretty low solution concentrations. Swirl while heating the vial/container with a lighter and voila, even dissolution.