• 💊 OTHER DRUGS 💊 Welcome Guest
    Posting Rules Bluelight Rules
    Notable Threads 1 Notable Threads 2
    Dangerous Combos Addiction Support
    Emergency Services Benzo Guide v.1
    Addiction Stories Scary Case Studies
    Biology, Pharmacology & Drugs 101
  • Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Opioids Morphine Mega Thread & FAQ'S

no, that's good you proceeded with caution:)

were your bowels empty at the time you plugged? it can sometimes take 30+ mins to hit as well, so just be patient:)

i always plug just after i've been to the toilet, otherwise the high will be deminished quite substantially
 
Yeah, I didnt feel anything from half of a 15mg Contin broken up and dissolved in a little hot water. Maybe I should try a little more next time.
 
TecK415 said:
Hey, I might get some morphine later on and I was wondering if it was worth it.

I have a bit of a tolerance, 60mg of oc or 25 mg opana gets me good. How much morphine would I need to get any good effects? from what I hear it aint too good.
Click to expand...


start with 100mgs of morphine and go from there. i get off on 40mgs of hydrocodone and 60mg of morphine had me feeling excellent. it's a different type of high though. some people like it some don't.

oh yeah what kind of morphine do you have? the IR's or ER's? i had the instant release. if you have the ER's i think you might possibly need more morphine.
 
MSIR Vs MSSR

Hey,

It 's easy to prep 12 hour MS caps, just dump beads into spoon and melt which leaves a low volume of clear solution, and a little wax from the beads coatings-which is easily removed.

Whats the best deal with the 10@20mg MSIR tabs? there easy to crush, and remove the thin film coating, but that leaves prolly 180-190mg of excipients and only 10-20mg MS. whats the best way of getting to the MS?

Thanks
 
to anyone who has problems with the ENDO 100mg MSER tablets, the green/blue ones.. i found the best way to break them down. i usually put one whole tab into a spoon, add around 1.5cc sterile water, heat until it just starts to lightly boil, then use the plunger end of rig to crush up pill, and before the wax surrounds the crushed pill, you can draw up at least 60-80mgs (estimate) before it turns all into wax. i know its not the safest, but hey, it worked for me.
 
update to OP

Popular types of morphine solutions

Pharmer.org - huge list of different morphine tabs out there for you to identify.

MS Contin; MS IR; Oramorph; Roxanol; Avinza; Kapanol; Kadian

Composition of Australian Mundipharma MsContins

mims said:
Composition

Active. Morphine sulfate BP.

Inactive. Tablets. Lactose (5, 10, 15, 30, and 60 mg tablets only), hydroxyethylcellulose, cetostearyl alcohol, magnesium stearate and talc. All tablets are coated with hypromellose, macrogol 400 and titanium dioxide (E171). The coatings also contain: iron oxide red (E172) (10 mg tablet); iron oxide black (E172) (10 and 100 mg tablets); iron oxide yellow (E172) (10, 15 and 100 mg tablets); quinoline yellow (E104) (15, 60 and 200 mg tablets); brilliant blue FCF (E133) (15 and 200 mg tablets); indigo carmine (E132) (15, 30 and 100 mg tablets); erythrosine (E127) and sunset yellow FCF (E110) (30 and 60 mg tablets).

Suspension. Xanthan gum, polystyrene sulfonate - hydrogen, xylitol, raspberry flavour 52354T, purified water, brilliant scarlet 4R (E127) as colouring.
Click to expand...
 
Okay,,, quick question: Can you still plug them if they gel? If you can foreseeably get the gel up there, that is? Or really, can you just get the coating off and "put a pill up there"..? I mean, it will dissolve eventually into gel, right? Is this still effective? Just curious, have a bunch of the jelly ones, and they do nothing orally, and nobody like jello snot, right?
Love y'all,
T.Doll
<3
 
200mg Ms Contin IV

Well I know you shouldn't IV pills but hey some people do right. Im familiar I was just wondering if the following inactive may cause extra damage namely the bold ones:

hydroxypropyl methyl cellulose
lactose mono hydrate
magnesium stearate
polyethylene glycol
silicone dioxide
titanium dioxide
triacetine
FD&C blue #1
D&C yellow #10 lake

Now I assume the silicone is the "wax" that the morphine is trapped in.

Also is the cold cook method still the best way to bag MS Contins?
 
itanium dioxide, also known as titanium(IV) oxide or titania, is the naturally occurring oxide of titanium, chemical formula TiO2. When used as a pigment, it is called titanium white, Pigment White 6, or CI 77891. It is noteworthy for its wide range of applications, from paint to sunscreen to food colouring, for which it was given E number E171.
Click to expand...

The pills are grey so this makes sense right?

triacetine seems to be a plasticizer so maybe thats the wax?
 
Because it is widely regarded as harmless, it is often used as a diluent[1] in the manufacture of medical tablets, capsules and powders (E470b)
Click to expand...

When used as a filling agent in the manufacture of capsules and tablets, such as vitamins, the source of this ingredient is typically bovine.[citation needed] However, there is an increasing number of vegetarian options in which the product specifically indicates it contains magnesium stearate from vegetable sources.
Click to expand...

Wat?

Magnesium stearate is a major component of "bathtub rings". When produced by soap and hard water, magnesium stearate and calcium stearate both form a white solid insoluble in water, and are collectively known as "soap scum".
Click to expand...

Soap scum in my veins?

It says no water soluable BUT maybe a simple cotton filter might put a layer of protection?
 
Besides your HR question are you planning on doing 200mgs Morph?
 
Yer i was gonna say 200mg!

MScontinns can be a pain-they gel up and all. Thoes 12 hour caps with beads are better, the beads melt and the wax on them can be removed, and filtered more cleanly.
 
Few opiate IV questions

Ok I just have a few questions about opiates. Please only people with true experiance/ valid info respond. First let me start out by saying that where I am from Oxycontin, Roxis (30mg percocet), and Morphine are pretty relatively avaliable. I have been doing Roxis and Oxys for a while now and can tolerate quite a bit.

My question is mainly projected toward morphine. I have acess to 100 mg boxed "M" "Gray Ghost" morphines. My buddy attempted to shoot one recently and he told me that he got very little usuable liquid from it and it geled up. After a little research I found out that it is because they are Morphine Sulfate Extended Release tablet (MS Contin). Now I know that there is a chemical formula for extracting the morphine but im NOT interested in that method.
I have heard that if you just dissolve the pill in a spoon, let it sit for 5+ minutes, put solution into barrel (with a piece of cotton in the bottom), push the solution through the barrel, repeat process, and then put final filtered solution into a clean syringe it is ok for IV use. I KNOW that there is NO safe way to shoot pills, especially MS contin (so please DO NOT LECTURE ME I know enough about drugs to realize the risk), but I have a heck of a tolerance and the roxis/oxys are getting too expensive. I've heard Morphine is just as good to IV and it is quite a bit cheaper mg for mg. Sooo....
1) Does the cold water extraction work well enough to make a MS Contin solution that can be shot ?
2) Morphine are cheaper (but this isn't a price thread so lets not get started there) mg for mg than roxis and oxys, but is the high just as good mg for mg ?

Informative, knowledgable, and worthwhile post only please.
 
eh i never have problems with my mscontins gelling up:\

Thoes 12 hour caps with beads are better, the beads melt and the wax on them can be removed, and filtered more cleanly.
Click to expand...

you don't ever want to add heat to any pill when you're prepping for IV. if you've got the patience with the beads, split them open and meticulously empty the morphine out of them:|

use micron filters!
 
When injected, morphine and oxycodone are probably equipotent in terms of recreational dosing.

I have only tried IVing oxycontin once, and I never injected morphine (outside of partially hydrolyzed heroin). So I don't want to tell you if your process on preparing MS contins for IV is viable or not.

However, there's probably an easier way to prepare them which would allow you to save more of the active ingredient. Take a look inside of my micron filtering mega thread.

Eventually this thread will be merged into the morphine mega thread.
 
welcome to bluelight:)

you'll find there's many many threads on morphine here in OD, there's even a mega thread i've comprised

actually, i'll merge this in there for you guys
 
Last edited by a moderator:
You must log in or register to reply here.
Top