• MDMA &
    Empathogenic
    Drugs

    Welcome Guest!

Moist Mdma

P

Peri

Greenlighter
Joined
Apr 8, 2010
Messages
3
If someone has moist, brown mdma what would be the best way to dry it out so someone could rail it. Just leaving it out of the bag would probly work but if you maybe put a hair dryer on it would that reduce potency?
 
Depends on how hot it gets. MDMA degrades in heat, which is why it is always best to keep it at around room temperature, stored away when you're not rolling. Using a hair dryer on it is a bad idea - it will most likely degrade. I've never had moist MDMA, but your idea of just leaving it out to dry off sounds good. Also, keep in mind that some of the MDMA may have disolved in the moist...
 
Ok thanks, more replies would be great!

Also I tasted a bit of it to see if it tasted the same as the last time I had it, it was way way more bitter this time it almost tastes salty. Is that good/bad/doesn't matter?

Thanks for replies :)
 
mmm moist mdma :S

Tell your supplier to keep his stash bag in a big jar of Dry rice.. jus like cocaine, it keeps it bone dry
 
it could be cut with meth cuz meth soaks up moisture very quickly and has damn near the same taste as u described
 
dam, now im kind of worried, i dont want to do meth i want my molly!

ive had it out on a cd for a day and i just put it near a fan where im guna leave it for a couple hours, it seems to have dried a little but not too much,

i just hope its molly
 
The more I think about, the more I wonder why your MDMA would be moist. If you cook it properly, it shouldn't be moist at all... either you don't have MDMA, or your dealer is a fucking idiot.
 
If have access to a lab or lab equipment you could try placing it in a dessicator.
Otherwise you could try placing it on absorbent paper and heating it in a conventional oven at very low heat (50° C). This will only help though if the relative humidity is low.
Creating a dry atmosphere would require you to make a moisture trap, which is basically a tube filled with calcium carbonate. One end of the tube is connected to the flask in which the material to be dried is contained and the other end of the tube is open to the atmosphere. You then apply very gentle heat to the flask. Don't let the heat in the flask get higher than 50° C.
So here again you would need some basic lab equipment.
 
if you have brown meth, whoever the chemist is is a fucking retard, meth isnt hard to synthesize, i would doubt it being meth, especially since apparently 50% of the meth in the US comes from mexico now, and the shit isnt called CRYSTAL meth for no reason, meth is too hard to cut compared to coke, and it doesnt change hands nearly as much as coke/smack, and its a hell of a lot easier to produce, and i wouldnt doubt the mexicans smuggle it over pure/uncut, apparently they have superlabs that synth kilos at a time.. Probably MDMA, if its anything active man. Hmm. Problem is, heating it in a bag, would condense in the bag methinks, and potential for mold/mildew. Id leave it out for a day or so in the sun, heat will degrade it, but not room temperature/low temps. What you could probably do is dissolve it in water, then boil off that water, or acetone wash it, that would maybe remove some of the cut too.
 
^ wouldn't boiling it degrade it as well?

Just leave it out, or, just dissolve it in water and then drink the water if you need to roll right away.
 
depends..i dont think it would hurt, considering you would only need a few mls of water, and i can guarantee you the boiling point of water is much lower than MDMAs, and the reaction itself generates heat when MDMA is made, he should be fine on like an electric stove i can guarantee you thats probably not gonna kill your MDMA..drugs dont degrade THAT easy.
 
You must log in or register to reply here.
Top