timerxsucks
Greenlighter
- Joined
- Feb 26, 2015
- Messages
- 7
SWIM did some reading on various sources about how to get at the Morphine in the ABG MSContins. SWIM had originally tried plugging 4 of the 15mg just crushed and mixed with 4ml of water with no effect. SWIM did the same thing again in about 2 hours and felt like SWIM had wasted them. SWIM had read about how people were prepping these for IV use and put together this method for plugging which worked with just 15mg.
What you need:
ABG MSContin
Filtered Water (or just tap water)
Table Salt
Cotton Ball or Coffee filter
Oral Syringe
Two Small containers to mix in
1) Remove the coating from the pill. You can dampen it and wipe it off with a paper towel or just scratch it off with your finger nail. Wetting it in your mouth and rubbing it off on the inside of your T-Shirt will work in a pinch.
2) Mix up a saline solution in a small cup. SWIM read that this part for IV use was important to get the mixture right. SWIM uses a quarter cup of water in a glass measuring cup and drops in a pinch of regular table salt and stirs it. To get it right you want to taste it. You should barely be able to detect the salt. Less salty than chicken soup.
3) Crush your pill into a fine flake. These are kind of waxy so you might have to chop up some flakes with a credit card or razor. The finer you can get this the better. Put your crushed up pill into a small shot glass or large spoon like a soup ladle.
4) Draw up 1/ml of the saline solution into your oral syringe and squirt it into the container holding your pill powder. Stir it around for a while and let it sit. The time release function will let go of the morphine into the saline solution. How much is unclear but the salt is the key here. It helps release the morphine better than any other method SWIM has tried.
5) Filter your solution by either dropping a cotton ball into the solution and putting the oral syringe in the middle of the cotton and drawing up the fluid through it or lay a piece of coffee filter over it and suck up the fluid. You should get most of your solution back without any gel. This part is probably not necessary but SWIM doesn't want any of that pill matrix getting in the way of absorption.
6) Use your preference of lubricant to insert the oral syringe up past your sphincter and empty the contents. You may wish to lay on your side for 20 minutes to help absorption.
Onset can be felt within 20 minutes. Remember it is best to start with too little and do more than to do too much and regret it. For best results do a bowel movement before so that your solution isn't absorbed by any feces. Wash and disinfect your syringe for later use. You may also add water to your remaining paste and drink it to get anything that may have been left over. Allowing the mixture to sit for a longer period may yield better results but SWIM waited about 5 minutes and the remaining paste had no bitter taste. SWIM says saline/pill mixture tasted bitter, which means it contained morphine. SWIM also learned that a smaller amount of fluid worked better but there is a maximum solubility of morphine in water around 60mg per 1ml. There is no need for heat. I searched but didn't find a similar method involving the salt. If it exists please lock/merge this post and chastise OP accordingly.
TL;DR Use some salt in your water when you plug ABGs. It works better.
What you need:
ABG MSContin
Filtered Water (or just tap water)
Table Salt
Cotton Ball or Coffee filter
Oral Syringe
Two Small containers to mix in
1) Remove the coating from the pill. You can dampen it and wipe it off with a paper towel or just scratch it off with your finger nail. Wetting it in your mouth and rubbing it off on the inside of your T-Shirt will work in a pinch.
2) Mix up a saline solution in a small cup. SWIM read that this part for IV use was important to get the mixture right. SWIM uses a quarter cup of water in a glass measuring cup and drops in a pinch of regular table salt and stirs it. To get it right you want to taste it. You should barely be able to detect the salt. Less salty than chicken soup.
3) Crush your pill into a fine flake. These are kind of waxy so you might have to chop up some flakes with a credit card or razor. The finer you can get this the better. Put your crushed up pill into a small shot glass or large spoon like a soup ladle.
4) Draw up 1/ml of the saline solution into your oral syringe and squirt it into the container holding your pill powder. Stir it around for a while and let it sit. The time release function will let go of the morphine into the saline solution. How much is unclear but the salt is the key here. It helps release the morphine better than any other method SWIM has tried.
5) Filter your solution by either dropping a cotton ball into the solution and putting the oral syringe in the middle of the cotton and drawing up the fluid through it or lay a piece of coffee filter over it and suck up the fluid. You should get most of your solution back without any gel. This part is probably not necessary but SWIM doesn't want any of that pill matrix getting in the way of absorption.
6) Use your preference of lubricant to insert the oral syringe up past your sphincter and empty the contents. You may wish to lay on your side for 20 minutes to help absorption.
Onset can be felt within 20 minutes. Remember it is best to start with too little and do more than to do too much and regret it. For best results do a bowel movement before so that your solution isn't absorbed by any feces. Wash and disinfect your syringe for later use. You may also add water to your remaining paste and drink it to get anything that may have been left over. Allowing the mixture to sit for a longer period may yield better results but SWIM waited about 5 minutes and the remaining paste had no bitter taste. SWIM says saline/pill mixture tasted bitter, which means it contained morphine. SWIM also learned that a smaller amount of fluid worked better but there is a maximum solubility of morphine in water around 60mg per 1ml. There is no need for heat. I searched but didn't find a similar method involving the salt. If it exists please lock/merge this post and chastise OP accordingly.
TL;DR Use some salt in your water when you plug ABGs. It works better.
