m.c.dot issues

[90's hangover]

i like to make some home made micro dots,for a special event but having difficulity with get them aqual by stregth .
some tips wil b helpfull
???

 

[Lost Ego]

bump for curiousity

 

[.:Holy::Toast:.]

IDK equal mixing powders in the microgram range could be difficult if you want to avoid hot spots
Perhaps dissolve LSD in lab grade ethanol (>=99.5%) so that one drop equals one hit, set your filler, drop it on, let it evap, then press.
I don't know I've never pressed pills nor dealt with lsd that wasn't either in solution or on blotters so this is just a shot in the dark

 

[Ballz_Trippington]

The above post is good advice but I would avoid using "drops" as 1 drop can be larger or smaller than the next.
A calibrated micropipette is mandatory IMHO.
For standard size blotters (roughly 1cm x 1cm) a 25ul pipette will be required.

 

[.:Holy::Toast:.]

Definitely do that^
IDK a much a micropipette costs, my lab instructors always say several hundred dollars but maybe that is just so we try harder not to break them

 

[kidklmx]

^They can be found for not a huge amount of $$$ on ebay. Though that's a troublesome process if you're doing batches, maybe less so with ethyl because of it's quick evaporation rate, but still..

You could try this method that's actually for snortable NBOMe powders, but I'd imagine with a bit of creativity you could get an evenly distributed powder ready for pill-pressing out of that

 

[Ballz_Trippington]

I was able to find quality fixed volume micropipettes for $40 by a quick google search.

 

[90's hangover]

dudes u know loads
thx

 

[90's hangover]

fuck swim !

 

[90's hangover]

dont sur about the powder-for sure it theoretcly best,but ther is the risk of exposing too bad condition buy not absorbing well.
ther is that material kinda jely/oily form,it makes the solution like absorb better -but i cant find the right one..
i did cpl of them each one bit difrent then the outer but im searching for a pinky readish one ~
tips ??

 

[.:Holy::Toast:.]

I'm not quite sure what you're asking haha
Crystal LSD will dissolve fully in laboratory grade ethanol.
However I'm not sure how quickly ethanol will evaporate out in a prepared solution.
If you prepare the solution of 25ul of ethanol per say 80-100ug of LSD, then you would have prepared a very small but potent ethanol/LSD solution, which would evaporate almost very quickly.
I'm guessing you're not preparing thousands of micro dots otherwise you probably wouldn't be asking this question.
Use a more dilute ethanol solution and have your piles of filler prepared before you make your solution so you can work quickly to prevent the ethanol from evaporating and causing a steadily increasing potency in your pills.
Maybe make little pockets of filler in tin foil per pill so you can put in half a mL or more of ethanol and let it evap without making a mess or losing product.

 

[bluedolphin1111]

I have no real advice to add. Good luck though.

Out of curiousity, why not make gel tabs or something easier? You don't have to answer that

 

[90's hangover]

asking if some one know a good material up to ethanol ..
something pinky readish,that make stuff absorb/blott better??

 

[90's hangover]

and maybe some one got a good recepy for a appls shtrudel ???