Opioids Iv'ing Eslon 100's

[Mr_Fluffykins]

theese are the XR morphine sulfate tablets, with little balls in them,
i have heard you can't just add water, and shoot as they jell up, and that there is a special technique to avoid the gelling up, i really don't wanna waste any as i only have 50mg till for two week and want a good nod, and oral 50mg would do jack shit,
i have sterile water, sterile filters, sterile cookers, and sterile needles, i know everything about harmreduction, and i am not a opiate addict, i useevery two weeks to a month, and i know all the risks, so i don't need a lecture just help thanks have a nice day

 

[BuddingPharmacist]

One of the people I helped a while ago lost part of an arm trying to defeat/shoot the jelling of the new water-reactive opiate time release pills they have out there now.

The jelly it turns into is more likely to form clots and kill you than it is getting you high.

I would strongly recommend against this. Seriously. Your arm/heart/brain >>>>>>> high for a few hours.

 

[Diloadid]

I think for the sake of harm reduction you shouldn't inject these, if they gel, lol. I never really run into morphine that gels up, unless it happens to be mscontin. I prefer the IV injection of the Ethix brand morphine, but I doubt those are in circulation anymore, being as they don't gel, and the 30mg look quite like some really dank h in a rig...

In all realities I don't think there is really a safe way to IV these, and i've managed to ruin micron filters trying, the gel morphine. I don't really know about the 100mg, outside of grey ghost.

If you want my opinion tho'; And this will probably be going against harm reduction.
> Remove coating on pill.
> Once coating is 100% removed, crush the pill as best you can, or if it is the capsules, crush the beads. (I know morphine doesn't like to crush well)
> Obtain Sterile Spoon + Sterile water + Sterile Syringe + Sterile Filter.
> Draw up a little extra water then however much water you will think you need.
> Place sterile water in sterile spoon.
> Apply slight heat, don't boil your water.
> Place medicine (crushed morphine) in heated water, slightly quick after you take the heat away.
> Apply filter, micron, to your rig and attempt to draw up the morphine, before it gels inconsistently.

I know that this probably isn't exactly how you should go about doing it, but this is the best I can tell in, with harm reduction in thought. Never apply much direct heat to your IV solution.

 

[rhythmtech]

If they are the same ESLON brand that is available in Canada, you should have no problems at all shooting them. In fact, they are generally preferred here because they DO NOT gel up at all. The beads crush into a fine powder which you can then add water, filter, and IV.

 

[Diloadid]

If they are the same ESLON brand that is available in Canada, you should have no problems at all shooting them. In fact, they are generally preferred here because they DO NOT gel up at all. The beads crush into a fine powder which you can then add water, filter, and IV.

See I've never ran into the Elson morphine. I think Ethix would probably be the equivalent in the states.