Stimulants IV Meth - Do you heat?

[Amphetafiendd]

Hey everyone!

I have been doing IV amphetamines since I was 17 and IV methamphetamine since about 21, I am now turning 24 in a weeks time. I have managed to keep life somewhat manageable throughout these periods and at university, although a lot of counselling due to emotional issues was needed. Anyway I'm going off track here...

So since I started using IV methods I have never used heat or mixed up a solution on a spoon. I have always just put water straight into a baggy with the product, dissolved using a bit of agitation; then well you know how the rest goes. So my question really is directed to those who use a spoon as a launch-pad of sorts to do your mix, do you guys use any kind of heat to help dissolve the gear quick and in a more successful fashion. As using a baggy sometimes it can be difficult when mixing up to properly dissolve all product to use in a singular shot.

I am asking this question as I keep my IV use to myself as I believe it is a private affair not to be discussed or shared in a social setting. Namely because of the stigma associated with it. Also I know very little people who use IV as their main ROA.

Just a little query! Look forward to your replies :3

 

[Beefy]

Never heat your meth. If it's clean stuff, it should dissolve in water after crushing it. There are 2 methods of IVing meth some people use. One is backloading. which is, you just drop your desired amount of shard in the back of the syringe, and draw up 30-40units of warm-hottish water. cap the rig and keep shaking it till it all dissolves. it shouldn't take that long. Now the method that more people seem to use is to crush your shards and put it in a cap or spoon. then add water and use the plunger if it all didn't dissolve(That probably means there's some cut in it(Depending on the shot and water amt. used)). then add a cotton, and draw it through the cotton.

 

[shroomster]

Never heat your meth. If it's clean stuff, it should dissolve in water after crushing it. There are 2 methods of IVing meth some people use. One is backloading. which is, you just drop your desired amount of shard in the back of the syringe, and draw up 30-40units of warm-hottish water. cap the rig and keep shaking it till it all dissolves. it shouldn't take that long. Now the method that more people seem to use is to crush your shards and put it in a cap or spoon. then add water and use the plunger if it all didn't dissolve(That probably means there's some cut in it(Depending on the shot and water amt. used)). then add a cotton, and draw it through the cotton.

word. Heating your product is unnecessary and will cook some of your product off. However, I admittedly do gently heat up my cooker sometimes because I'm impatient, as it's a little faster.

 

[brutus]

Meth is water soluble, so if you heat it up then all you are doing is dissolving inactive cuts.

This could have been found easily by using the search engine.