• Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Opioids injection questions

Doped2go

Greenlighter
Joined
Oct 15, 2010
Messages
14
I've injected opiates many times, but all pharm prepped drugs that I did not have to prepare in any way. here is my question for those with more experience with preparation than I:

1. what is a suitable filter for straining crushed pills? Might have access to some morphine tablets. Would a coffee filter remove an acceptable about of the junk from the solution?

2. I know liquid morphine has many additives, but is anyone familiar with roxanol? it is 20mg/ml, a higher concentration than some other oral prep's, and it does not contain sugar (tastes awful!). I would rather inject this, but of course don't want to fuck my veins up.

I take my risk mitigation seriously and have all sterile equipment and no scarring or tracks. Anyone with experience or information please fill me in!
 
I have shot up a fair share of pills during my addiction. The process I used, though it may not be very healthy - was essentially the same as if I was shooting up heroin. I would crush the pill beforehand, dump the powder in to the spoon, use cold water only and never heat it up, mix it up well with the plunger, then filter it through a piece of cotton from a q-tip. I've never shot up morphine pills though, they always had waaayy too much nasty stuff in them. My method would only work for pills like oxy's, dilaudids, or anything similar. If you really want to shoot up morphine I would wait til someone posts about their experience with them, cause I have none. Hope what I could offer you helps though. Good luck and be safe, - disposable_hero
 
from my experience the only pills that are safe to shoot are the types with minimal fillers. pills like OC, or pure oxycodone pills.
and as far as filtering i use cotton makeup remover pads. they are already tightly would. i pull off a bit and roll it as tight as possible. basically the tighter your filter the more junk it will block.
be careful and good luck
 
theres a short and long version to this answer:

you should be using a micron filter disc attached to a luer type syringe. to briefly answer your question. also you should source these off the internet.
 
check out these threads.

Micron Filtering Mega Thread and FAQ

Injection; IV Complications and Information MEGATHREAD and FAQ II - show me the blood

IV Product Review Thread

Inactive Ingredients A to Z

Case Studies (It could happen to YOU...) **UPDATED: 15 JAN 2010**

do not go injecting an oral solution, that's an almost sure fire way to lose a limb and cause yourself some great difficulties. just imagine how bad the viscous solution must be coursing through your veins. use them as intended, orally.
 
I thought I was sourcing off the internet (bluelight.com)
thanks for the info. Don't know where I can get micron filters, but I will see. Have access to some healthcare supplies but we don't stock micron filters here.
 
we allow links to sites that specifically and only sell harm reduction tools, ie - filters, syringes, swabs, bacteriostatic water, etc:)

if a site contains links to other site which sell questionable products then it is not allowed to be posted as it's essentially soliciting drugs

if you bother to click and read any of the links i posted above, the IV Product Review thread and Micron Filtering thread have links to sites which sell filters, etc.
 
Top