Injecting OxyContin 80 mg pain tablets

[Pirate pete]

I have been injecting my OxyContin 80mg tablets for a few years. I usually wash the green coating off ,crush put in spoon add around 1 ml of water heat then use the other end of the syringe to push down on the crushed tablets until i bring them all back together again,pushing down until all the wax clings together ,I continue to work the mixture until the amount of tablet is around an fifth of the size ,I then use a filter and pull the mixture into the syringe ,my question is is this the best method to get the most morphine out of the tab and into my vein to get the maximin amount of pain releif

 

[thesameoldfears]

If they are OxyContin, they contain oxycodone, not morphine.
Never heat your pills.
And if there is "wax" in the spoon, you probably have an OP which are just not safe to inject.
Really, no pill is safe to inject, particularly without a micron filter.

 

[Venrak]

Bdd -> OD

 

[Pirate pete]

Well matey what is the best. Way to do it. That's what I need to know.

 

[thesameoldfears]

I'm still confused as to what type of pill you have. Do they say OC or OP on them? Do they have any other markings?

 

[Hydromorfiend]

You are doing it the "best" way... Personally I haven't used another spoon to crush em.. But to make it a little stronger you might want to try to add less water when you suck it up, then add more water to your wash and suck that up all into one shit. That way you get both, the wash and your initial smash in one rig.. If that helps. Won't make much of a difference tho.

 

[Mr.Scagnattie]

Using a micron filter is the only safe way to inject any pill.. but honestly, IV'ing oxycodone is pretty pointless. The bioavailability is so high via the oral route, that the slight increase given by IV'ing, just doesn't justify all the risks associated with shooting up. Also, for the majority of people, IV oxy produces no real rush, so there really is no point.