injecting hydromorph contin

[freebasebilly]

Forgive me if this is already been discussed and answered and posted already, but I’ve searched almost everywhere for this on this site and I can’t find anything with good instructions. Some backround knowledge I’m on 95mg methadone and hydromorph contin 36mg daily. How do you prep hydromorph contin for iv? what do I use to break it down/dissolve it? as it is extended release and it feels like I’m not getting a buzz when I iv them. Tbh I think I’m doing it wrong because I get a better high when snorting every time I have done an iv, I feel like I injected water. A dose that could be high enough to give me a rush is so much powder after crushed I’d need like 3 full rigs filled with water. My method has been as follows most I did at once was 36mg due to the beads just soaking up the liquid, crush beads into fine powder, squirt in a full 100units/1ML of water stir like crazy then suck it up with a filter and go. But I feel nothing at all, should I add vit c? Should I heat it? Use warm water from the beginning please tell me what’s going on here and what I’m doing wrong. Is it my tolerance? I’m definitely not missing so what’s the deal

 

[paranoid android]

I used to wrap the hydromorph contin in paper, crush it by rolling a steel weight over it then suck it up with a micron filter

 

[freebasebilly]

I used to wrap the hydromorph contin in paper, crush it by rolling a steel weight over it then suck it up with a micron filter

So pretty much what I was doing but does the drug itself dissolve in water that was a dumb question I mean like do I have to use anything other than water to prep it for an IV do I need vitamin C or vinegar or heat and how do I get enough into the rig because it seems like it just soaks up all my water do I crush it up dissolve a little bit at a time suck that up dissolve a little bit more suck that up dissolve a little bit more and so on how do I do this because it doesn’t make sense that I’m getting more high off of sniffing it than I would injecting it is it may be my tolerance

 

[paranoid android]

So pretty much what I was doing but does the drug itself dissolve in water that was a dumb question I mean like do I have to use anything other than water to prep it for an IV do I need vitamin C or vinegar or heat and how do I get enough into the rig because it seems like it just soaks up all my water do I crush it up dissolve a little bit at a time suck that up dissolve a little bit more suck that up dissolve a little bit more and so on how do I do this because it doesn’t make sense that I’m getting more high off of sniffing it than I would injecting it is it may be my tolerance

Nope hydro dissolves just fine in water

 

[Time2Fly120]

I used to wrap the hydromorph contin in paper, crush it by rolling a steel weight over it then suck it up with a micron filter

Swim has hydromorphone ir. Its easily dissolved in water. I keep hearing of this micron filter. Can you tell me what it is or leave a link.

 

[paranoid android]

Swim has hydromorphone ir. Its easily dissolved in water. I keep hearing of this micron filter. Can you tell me what it is or leave a link.

A micron flter is quite simply something that filters the solution so its fit to inject. Its a must have for pills. But with instant release dilly you can get way with not using a micron filter somewhat

Sadly they can be expensive and hard to find now. I havent had any luck in finding any cheap sources for micron filters in ages

 

[Time2Fly120]

A micron flter is quite simply something that filters the solution so its fit to inject. Its a must have for pills. But with instant release dilly you can get way with not using a micron filter somewhat

Sadly they can be expensive and hard to find now. I havent had any luck in finding any cheap sources for micron filters in ages

Are you allowed to provide where people can find these for harm reduction? Swim had experienced the west part of Texas and learned about BTH. Holly cow the desperation. Swim just wanted good old East Coast dope you could bump but it was not the same over on the western part. Hydromorphone looks like a fucking god send. Swim swears with the flush kits swim got from the hospital that are basically salien a simple cotton for the little if any white residue is even left after turning it to sand and pouring it in a clean cap. It looks just as good as the vials at the hospital and here where may need to make a new post. Here it goes.
Swim wants to know Is there a way to make a IM solution of Hydromorphone. Swim was sore for a week for slamming BTH into his theigh after being unable to hit a vein a had to go to work to repeat the madness. Many years ago. He figured .2g or 200mg equals 1mg of Hydromorphone. He did the math once and the 8mg pill weighs .15-1.6 meaning .2g or 200mg would equal approximately 1 mg of Hydromorphone (apparently hydro is 5 times more potent, making it equal 5 mq of oxy)
Thankfully Swim gets enough and finds the best route is to just swallow them, possible bump a little but not 2 pills worth when you feel it all on the back of your throat. You end up swallowing most of it through your nose if you think about it. Swim Also heard a recepie that is a spray bottle with concentrated Hydromorphone....Interesting

 

[paranoid android]

Whats BTH?

Also IMing pills is not safe its far more dangerous then IV.

Yes you cn post where to find micron filters. If they ship all over Canada also send me the link as im looking for micron filters myself. The needle exchange here stopped carrying them.

 

[freebasebilly]

Whats BTH?

Also IMing pills is not safe its far more dangerous then IV.

Yes you cn post where to find micron filters. If they ship all over Canada also send me the link as im looking for micron filters myself. The needle exchange here stopped carrying them.

Are micro filters literally just those little cotton cylinders

 

[paranoid android]

Are micro filters literally just those little cotton cylinders

Nope. Mine are made out of plastic and something else. No cotton in there

 

[ControlDenied]

The best way to prep hydromorph contin is to put the beads in your spoon, and some cold water, and let it soak like that for an 1 hour plus. Then they become soft and you can just crush them with the needle cap on. Easy peasy.

 

[freebasebilly]

The best way to prep hydromorph contin is to put the beads in your spoon, and some cold water, and let it soak like that for an 1 hour plus. Then they become soft and you can just crush them with the needle cap on. Easy peasy.

And when you do it with this method by letting them soak in the water and what not when you crush them up after they soften up in the water all broken up does the solution that you have to drop have a bunch of like filler and pasty mush in the bottom