I finally figured out how to build the machine(DMT) without a drill or tape.

[Havocsfool]

So I was at it for two days, using just a screw driver is a pain in the ass. The three tools that give anyone the ability to make the machine multiple times without a drill or tape are a hammer, screw driver philips head, and a normal manual glass cutter(cost is about $3.60). You just turn the glass cutter like a key while applying downward pressure then once you think you are deep enough, give it a wack with the hammer and screw driver. It should make a clean hole, finish the edges out with the glass cutter again. Finally, I couldn't find anything on this after searching except hitting the bottle with a hammer and screw driver and hoping for a clean break and then taping it if it doesn't break clean.
Total this cost me $6 to make the machine, but I had the hammer and screw driver already, so I just had to buy the bottle, chore boy and glass cutter.

 

[Havocsfool]

Couldn't find anything that wasn't just smash on the concrete with a hammer. Basically I wanted a way that wasn't just smash and hope for the best without a drill. All you need is a bottle, hammer, screw driver, cheap-o glass cutter ($3.60), chore boy and straw. This is quick too, took me 10mins. Just turn the glass cutter like a key back and forth, once it's enough hit with hammer and screw driver, come back with glass cutter to smooth it out, then put you're straw and chore boy in. Viola!! Good to go without a drill or electrical tape. Cost me $6.50ish.

 

[Keif' Richards]

Closed. Read the forum guidelines guys. We cannot have synthesis discussion ruining our already questionable reputation the public at large. Post this information or glean it from the darknet like everyone else.