The Dope Man
Bluelighter
I take no responsibility for any harm you cause to yourself or others while attempting this technique. This post is a work of fiction and for harm reduction purposes only.
This method is by far the best,hardest hitting,quickest prep time, and most importantly safest way I have found to IV morphine er pills. ( works great for almost ANY pill morphine or not ).
I have tested this method on 100mg endos, mailis, and watson ABG's. works perfect for all of them and I end up with a crystal clear shot every time.
water ( preferably distilled or at least bottled )
cotton ball ( micron filter would be MUCH better )
cooker ( I use the bottom of a pop can )
table salt
lighter / candle
your Morphine er pill
PROCEDURE
1) Get out all your IV supplies and make sure they are clean and sterile and also that you have a clean work station.
2) Remove the coating of the pill if it has one. Taking great care not to get the pill to wet if you use a method with water. ( DO NOT USE SPIT OR PUT THE PILL IN YOUR MOUTH )
3) Crush the pill into as fine a powder as possible and place it on the edge of a credit card
4) Get a glass of water and add enough salt to it so it taste decently salty. ( not ocean salty )
5) Using one of your 3ml rigs draw up 3ml of water and squirt it into your cooker
6) Slowly bring the water in your cooker to a simmer for about 5 seconds ( count to 5 once it starts simmering )
7) Quickly dump your morphine into the cooker and cook it for another 5 seconds
8 ) Grab you cotton and dunk it in your glass of salt water and throw it in your cooker
9) Using a new clean syringe draw up the solution through a cotton
10) You should now have 1.5-2.5ml of crystal clear morphine solution in your rig ( it should look like water )
11) Squirt a small amount of the solution in your mouth. it should taste very bitter. if it does your ready to go.
12) Bang
13) Roll around on the floor for 5 minutes because the pins and needles HURT SOOOO GOOD
14) Nod
Thats it !
if you have any questions feel free to pm me or post in this thread.
This method is by far the best,hardest hitting,quickest prep time, and most importantly safest way I have found to IV morphine er pills. ( works great for almost ANY pill morphine or not ).
I have tested this method on 100mg endos, mailis, and watson ABG's. works perfect for all of them and I end up with a crystal clear shot every time.
SUPPLIES
2 3ml syringeswater ( preferably distilled or at least bottled )
cotton ball ( micron filter would be MUCH better )
cooker ( I use the bottom of a pop can )
table salt
lighter / candle
your Morphine er pill
PROCEDURE
1) Get out all your IV supplies and make sure they are clean and sterile and also that you have a clean work station.
2) Remove the coating of the pill if it has one. Taking great care not to get the pill to wet if you use a method with water. ( DO NOT USE SPIT OR PUT THE PILL IN YOUR MOUTH )
3) Crush the pill into as fine a powder as possible and place it on the edge of a credit card
4) Get a glass of water and add enough salt to it so it taste decently salty. ( not ocean salty )
5) Using one of your 3ml rigs draw up 3ml of water and squirt it into your cooker
6) Slowly bring the water in your cooker to a simmer for about 5 seconds ( count to 5 once it starts simmering )
7) Quickly dump your morphine into the cooker and cook it for another 5 seconds
8 ) Grab you cotton and dunk it in your glass of salt water and throw it in your cooker
9) Using a new clean syringe draw up the solution through a cotton
10) You should now have 1.5-2.5ml of crystal clear morphine solution in your rig ( it should look like water )
11) Squirt a small amount of the solution in your mouth. it should taste very bitter. if it does your ready to go.
12) Bang
13) Roll around on the floor for 5 minutes because the pins and needles HURT SOOOO GOOD
14) Nod
Thats it !
if you have any questions feel free to pm me or post in this thread.