Let's just start with I already know how dangerous and powerful fentanyl is. I know that many many people OD using it because it is such a potent drug and small amounts in variation are the difference between getting high and ending up in a coffin. Yes, I know the story of the guy on this site who Od'd using Fentanyl. I don't need to be told that this is stupid, wreckless, or anything along those lines. I am simply asking for information, not moral or life guidance.
I am contemplating purchasing about 50mg of Fentanyl powder. More than likely I will IV it since that is how I take all my drugs. I found that a dose of 100 micrograms (0.1 mg) is approximately equivalent in analgesic activity to 10 mg of morphine. I know how powerful this drug is and that it is measured in microgram amounts, so the 50mg would translate in 5000 micrograms of Fentanyl. I was thinking of either diluting all the powder in Bacteriostatic water or in Inositol powder and then mixing it up. I feel like this is the only decent method to measure one's dosage is through dilution in a much larger base material.
Based on the above numbers I am thinking that a 500microgram (.5mg) would be about the equivalent of 50milligrams of morphine. I think this would be a decent starting dose and I could titrate upwards based upon the effects. I am thinking about placing the 50mg of Fentanyl in 10ml of of Bac. Water and this would leave about 1000micrograms per ml of water, so about 2/3 of a ml should be a solid dose.
Is my math about right here or is there something I am missing something. I was thinking that 50mg should provide more than 10 decent shots, but if my math is correct than that is how it works out. Anyone have any suggestions besides preaching about how this is a bad idea?
I am contemplating purchasing about 50mg of Fentanyl powder. More than likely I will IV it since that is how I take all my drugs. I found that a dose of 100 micrograms (0.1 mg) is approximately equivalent in analgesic activity to 10 mg of morphine. I know how powerful this drug is and that it is measured in microgram amounts, so the 50mg would translate in 5000 micrograms of Fentanyl. I was thinking of either diluting all the powder in Bacteriostatic water or in Inositol powder and then mixing it up. I feel like this is the only decent method to measure one's dosage is through dilution in a much larger base material.
Based on the above numbers I am thinking that a 500microgram (.5mg) would be about the equivalent of 50milligrams of morphine. I think this would be a decent starting dose and I could titrate upwards based upon the effects. I am thinking about placing the 50mg of Fentanyl in 10ml of of Bac. Water and this would leave about 1000micrograms per ml of water, so about 2/3 of a ml should be a solid dose.
Is my math about right here or is there something I am missing something. I was thinking that 50mg should provide more than 10 decent shots, but if my math is correct than that is how it works out. Anyone have any suggestions besides preaching about how this is a bad idea?