In my morphine experience, plugging is the best way to go(save for IV, of course) to get the best effect. I recently acquired some time release morphine, which has complicated how I plug. I cannot seem to be able to bypass the time release. I have tried to crush it into an extremely fine powder, and yet when I mix it with water there is always clumps which are difficult to get into the needle-less syringe. When I finally get it all into the rig and plug the solution, there is no familiar rush that I get with MSIR. All that happens is I get a very slow onset, followed by a 4 hour wait to feel the full effects.
My question to you is how have you found ways to separate the time release wax from the morphine, and plug it with a good rush? I was considering soaking the morphine for up to a couple days, or possibly add a small amount of alcohol in attempt to dissolve the wax matrix. If any one has done this or used another method with success, I would much appreciate you sharing your techniques with me.
I am dedicated to plugging morphine because I find there is no other method of ingestion for this particular opioid that gives nearly the same effects. Eating and snorting has never done anything for me, so I am trying to make the most out of my small supply.
Any help is much appreciated
J-Dub
My question to you is how have you found ways to separate the time release wax from the morphine, and plug it with a good rush? I was considering soaking the morphine for up to a couple days, or possibly add a small amount of alcohol in attempt to dissolve the wax matrix. If any one has done this or used another method with success, I would much appreciate you sharing your techniques with me.
I am dedicated to plugging morphine because I find there is no other method of ingestion for this particular opioid that gives nearly the same effects. Eating and snorting has never done anything for me, so I am trying to make the most out of my small supply.
Any help is much appreciated

J-Dub