e-z test application

[shank]

I have just got an e-z test and have tested about 10 pills. Every time I drop the liquid onto a scraping it pours out fairly quickly and i always get about 4 drops of liquid instead of one drop. The kit is sposed to test 200 pills and i have done 10 and used half the liquid. Is this right or have i got a bad dropper or somthing. I havent used one before so would like to know if this is right or not. Is there a special way of pouring the liquid out that will reduce the amount of liquid. Whenever i dont fully turn the bottle upside down the drop pours into the lid of the dropper instead of onto the plate.

 

[Kaister]

One drop is definately enough. Four drops for one test is a waste. I think you must have a slightly faulty seal at the top of the bottle.
With my test kit, if I turn it upside down, it won't drop until I tap it a little. Could be that the seal on your kit is split.

 

[aj]

Yes, it is the way you are holding it, experiment a bit with it.
The dropper is in for improvement, actually the whole test is going to be improved ;-)
aj