• Psychedelic Drugs Welcome Guest
    View threads about
    Posting RulesBluelight Rules
    PD's Best Threads Index
    Social ThreadSupport Bluelight
    Psychedelic Beginner's FAQ
  • PD Moderators: Esperighanto | JackARoe |

DMT and bongs

TangerinO

TangerinO

Bluelighter
Joined
Nov 30, 2010
Messages
1,322
Location
Australia
Okay here's the deal. I have 60mg of DMT, and I just recently broke my glass pipe.
I don't have any normal pipes, I have heard of people smoking through them using weed or tobacco on the top and bottom to ensure it's not burned.

Is it worth it to do it through a bong? It's the only smoking device I have in my house and after two failed attempts due to not enough in the pipe, and another where I only got a little effect, I don't want to waste the last of it.

If I smoke through a bong and burn it carefully with weed and backy on the top and bottom will it be wasted?
 
I would say that purely because you can take a bigger hit it will be better. Just use the same precautions that you used with a pipe.

Now with that being said, there is always the possibility of some of the DMT being left in the water.
 
Would you recommend a thicker layer on the top or the bottom?
And I suppose I would burn really slowly on the top and pull softly so I could vape all the dimitri and then eventually burn through and rip, right?
 
Try using a jet lighter and not touch the flame directly to the matter in the cone piece. The heat is high enough that it will vape the dmt and your set :)

Ive watched my friend do it, and after he sandwhiched it, he put the flame above the cone but didnt touch it and melted the dmt into the weed. Then smoked it as normal. I dunno if this had any benefit but yeah.

Say hi to the spirits for me!
 
I don't have a jet lighter, so I'm starting to reconsider, the last thing I want to do is waste it.
 
You don't necessarily need a jet lighter, a regular bic will do the job when smoking deams on top of weed. Just don't put the flame directly to it, hover it as close as it needs to be. Also, I'm not exactly sure why but apparently it's best to use a bong that has no water in it when smoking deamsters mixed in with herb (I've seen posts from blers who are definitely veteran psychonauts that recommend this.

All of the times I've smoked dmt have been on top of bud and with a regular glass pipe, and believe me, it gets the job done. However, if you want to get the most out of your deamsters you may want to look up "The Machine" which is a very effective and easy to assemble dmt smoking device.
 
A bong is great for DMT. As mentioned, you can take bigger hit right into your lungs as opposed to pulling smoke into your mouth and then inhaling ala pipe. My "technique" is to mix the DMT with a herb (used to be weed when I smoked weed, nowadays just tobacco) on a plate or any flat surface, make sure you have the DMT quite well dispersed though the herb. Put a bit of herb in the bottom of the cone, add your DMT/plant mix, put a bit more plain herb on top and voila. Just keep te lighter a safe distance from the cone when you smoke, pull slowly so you vaporise all the material, smoke fills the chamber, and then inhale it, drop your bong and start behaving like a monkey.
 
Every dmt trip I've taken has been with a bong full of water, with the dmt inbetween two layers of weed. Not to much on the bottom and just enough to barely cover the layer of dmt on the top. Works perfect for me. Just remember its better to under-heat it then to over-heat it if you are worried about wasting any. You can always try again if you didn't apply enough flame.
 
peacelovedope said:
You don't necessarily need a jet lighter, a regular bic will do the job when smoking deams on top of weed. Just don't put the flame directly to it, hover it as close as it needs to be. Also, I'm not exactly sure why but apparently it's best to use a bong that has no water in it when smoking deamsters mixed in with herb (I've seen posts from blers who are definitely veteran psychonauts that recommend this.

All of the times I've smoked dmt have been on top of bud and with a regular glass pipe, and believe me, it gets the job done. However, if you want to get the most out of your deamsters you may want to look up "The Machine" which is a very effective and easy to assemble dmt smoking device.
Click to expand...

Thanks man, yeah I had a chat with a good friend last night who has recently discovered a love for DMT. He also said that no water was a necessary, or warm water, as if it's not it causes the DMT to recrystalise and that would suuuuck!
As for the machine, I've actually smoked DMT three times before, twice with the machine. Last time I smoked 40mg through the machine, but I think it may have been my breathing technique, I don't really remember much of the experience except a golden aura entering my body and the soft sensation of my face being peeled back. That and robotic tentacles in the distance of my third eye. Although this sounds crazyish, it was quite normal, there were no open eye hallucinations at all, and it was quite mild but very very pleasant.

And as for trying again, I spent months finding this DMT and I imagine it will likely be months again before I can get more. In my experience most people that have it hold on to it like grim death, scuse the pun? That's a pun right :D
 
Personally my favorite way of smoking deamsters is via a glass piece because you can take a larger hit. And the way I found most effective for packing it mixed in with any various herb (Marijuana being the best choice) is to pack a solid amount of green on the bottom of the cone to make a flat surface on the bowl, then pack the deams on roughly 3/4ths to 4/5ths of the weed depending on the size of the bowl, then pack a rather thin layer of green over it. When you light it, light the green with no deams directly underneath it and get it cherried well. If this is done right, the heat from the burning green will be enough to vaporize the deams without the risk of the lighter's flame messing it up.
P.S. One small piece of advice. I have seen more than one piece be broken while under the influence of DMT, and every single one of them has been a water filtrated piece. So when you go about trying it, for your sake, make sure it is safe while you start tripping.
 
I prefer to smoke DMT with a crack pipe style setup fitted into an empty water bottle to concentrate the smoke. By crack pipe I mean go to a gas station and get one of those little glass tubes with a fake flower in it. Take out the flower, rinse out the glass. Get some new copper scrubber stuff, cut a small amount off (enough to fill about 1/4 of the glass pipe) and torch it a little with a lighter to burn any contaminants off, then rinse it off. Stuff it in the end of the glass, then a little farther in. Then make a plug of more copper doing the same thing, just enough to fill the rest of the glass. put the DMT on top of the copper and put the plug over it. For the water bottle just cut a hole in the side near the bottom that's just a bit smaller than the pipe and stuff the pipe in there, and put a carb on the other side in a spot comfortable to hold from. Then lay down, hold the lighter a little away from the tip of the pipe and inhale. If the smoke that comes out tastes burnt or is too thick put the lighter farther away. Fill the water bottle with smoke, inhale and hold it for 20 seconds each, you should break through on the 3rd or 4th hit. It's very efficient. I've heard some people say that smoking through copper is bad for you, but that's just hearsay and you shouldn't be smoking DMT often enough for it to cause health issues even if it's true.
 
Scunch said:
I prefer to smoke DMT with a crack pipe style setup fitted into an empty water bottle to concentrate the smoke.
Click to expand...
What is your reasoning behind crafting a crack pipe as supposed to using a glass piece, whether or not water filtrated. I feel that making a piece has a much larger chance to be inefficient than a glass piece designed specifically to be smoked out of.
 
I would say doing it in a crack pipe would be the most efficient as you know your not burning. But damn is it fucking harsh, wow.

Changa in a bong would have to be the ultimate however. Just so eaaasy.
 
Rolling Sly said:
Changa in a bong would have to be the ultimate however. Just so eaaasy.
Click to expand...
I'm glad you mentioned changa as it is most definitely my favorite form that dmt exists in. I'll be damned if a good sized bong hit or two held in for a good bit won't get me broken through.

Also, randomly, I have to say that dmt + alcohol is possibly my favorite way to do dmt. Although one hit off of a bong of some straight pure powder dmt when I was at a party drinking with friends sent me to a whole other universe that I couldn't fully even visualize clearly because of the intoxication. Wierd stuff.
 
So yeah I literally just got done with a DMT trip using a bong. And may I say... Please be careful. This was probably about my 200 and some odd dmt trip... I put about 3/4 of a bowls worth of none other than catnip into my 8 perc 15" beaker bottom royalty bong then topped that with ~100mg of DMT (the white stuff =]) and filled the rest of the bowl with catnip. So I took a very small rip and wasn't convinced fully that I had even wanted to trip (as is most cases with DMT) and didn't feel anything... So I took 2 more good sized rips out of the bong... No cough... Then completely lost reality and somehow stumbled to my bed and closed my eyes... The most intense experience I've ever dealt with. I completely lost my mind. I thought it was gone forever and I was going to have to start killing people to get it back (yeah ik doesn't make any sense and may even seem a bit scary to you) but I was completely afraid of myself because I didn't seem to care that this was happening. I was legitimately afraid that I wouldn't come back this time. It was the long awaited blast off I have been looking for as of recent. It totally blew my mind and as I said I've used dmt over 200 times... This really brought me back to reality and showed me a side of myself I don't want to bring back to the surface... DMT is no "fun" drug, so be careful with what you got there. Not to mention I went back to my bong afterward and it looked as if I hadn't even smoked anything yet. I was too afraid to smoke any more (which is a very weird response for me after finishing a session). So to answer your question, a bong will be sufficient, haha.
 
I literally just come up with the best way..

Get a 2 litre bottle and cut the very bottom off (leaving the mouth bit)..

Get some tin-foil and make it into a rather large spoon shape keeping the bowl part of it big.. enough to almost fill the bottom of the bottle.. and make keep the bowl part is only one sheet thick..

Hold the bowl of the spoon under the bottle.. covering the section you cut off.. get a friend to keep a flame underneath the bowl of the spoon (not touching the foil)..

Inhale through the mouth piece..

I've tried all sorts and this way was by far the best.
 
Instructional video on how to create a makeshift DMT pipe from, as mentioned above, a plastic bottle and foil. Makes it's really simple. :)

 
You must log in or register to reply here.
Top