Benzos Dissolving Etiz into PEG properly? Volumetric dosing

[lolwhatzdrugs]

I put 100mg of Etizolam into 10mg of PEG and had been dosing .1-.2ml at a time (1-2mg) but it still isn't dissolving, and I sucked from the section without much specks, so I figure I didn't even get 1-2 each time. There are big piles of etiz under that PEG I think. Hard to take a picture, totally.

I looked and looked but am non the wiser, does it need to be heated while stirred? I crushed up the powder super well and it still won't go into a homogenous solution, pic (big pic, 1000+pixels:

NSFW:

What shall I do???

Heat it up? Keep agitating? Take a knife and try and crush the little specs into smaller specs and on and on, or all three?

 

[Pill__Head]

Just add heat and keep mixing. Ive done the same thing, multiple times with alprazolam powder. It works great, just seemed to take a while to get all the small particles totally dissolved.

HEAT is your friend!

 

[lolwhatzdrugs]

Would throwing it in the microwave for 3 seconds at full power or 20 seconds at 10% power be to much, or should I just highly heat the same amount of PEG used, and add it too the already made solution just to make it half strength, whatcha think?

 

[Pill__Head]

Personally, I would try lower power for a longer time in the microwave, if you must use it..

I just use super hot tap water and run it over a glass vial of my mixture while shaking it until all particles are gone. . .

 

[lolwhatzdrugs]

Personally, I would try lower power for a longer time in the microwave, if you must use it..

I just use super hot tap water and run it over a glass vial of my mixture while shaking it until all particles are gone. . .

So:

• Heat for 30sec at a time at 10-15 precent power,
• 1-2 min inbetween heatings
• stirring rapidly inbetwen.

That sounds good? It's a plastic dosage cup I'm using