arthunter888
Bluelighter
- Joined
- May 23, 2009
- Messages
- 623
Okay, so the dope I get is usually quite stepped on. This recent batch when snorted, caused a painful burning sensation alternating to a cooling sensation, etc. Then this was followed by nose-bleeding, so this was alarming.
I was thinking of a crude (for snorting) cold-water-extraction method to remove at least the insoluble cuts. Here's what I thought of...
1) Place ice cubes into a cup of cold water, wait 5 minutes.
2) Dump a bag of dope (avg. mass 30-50mg according to milligram scale--I know--pathetic
) into a shot glass.
3) Use an oral syringe to draw up 2mL of the cold water.
4) Dispense the 2mLs water into the shot glass, then stir with toothpick for a minute.
5) Dip a cotton ball into cold water to pre-wet, then squeeze out water with fingers.
6) Remove plunger from oral syringe, then stuff the pre-wet cotton to the base with a paperclip, which occupies about 2mLs after squeezing down.
7) Dump (or use a 2nd oral syringe to squirt) the dope solution into the cotton-syringe.
8 ) Slide plunger back in, and dispense the dope solution into the shot glass, squeezing hard at the end to release most of the solution.
9) Unscrew the cap/pump from a nasal spray bottle, and dip the straw into the shot glass dope solution.
10) pump solution into nose, about 1-2 sprays each minute to minimize dripping into throat. takes about 5 minutes to finish, then the very last "puddle" that can't go up the straw can be squirted in with a small eye dropper.
-----------------------
So, does this seem like an effective and efficient way of doing this. What would you change, such as amount of water or soaking time, etc?
I was thinking of a crude (for snorting) cold-water-extraction method to remove at least the insoluble cuts. Here's what I thought of...
1) Place ice cubes into a cup of cold water, wait 5 minutes.
2) Dump a bag of dope (avg. mass 30-50mg according to milligram scale--I know--pathetic
) into a shot glass.3) Use an oral syringe to draw up 2mL of the cold water.
4) Dispense the 2mLs water into the shot glass, then stir with toothpick for a minute.
5) Dip a cotton ball into cold water to pre-wet, then squeeze out water with fingers.
6) Remove plunger from oral syringe, then stuff the pre-wet cotton to the base with a paperclip, which occupies about 2mLs after squeezing down.
7) Dump (or use a 2nd oral syringe to squirt) the dope solution into the cotton-syringe.
8 ) Slide plunger back in, and dispense the dope solution into the shot glass, squeezing hard at the end to release most of the solution.
9) Unscrew the cap/pump from a nasal spray bottle, and dip the straw into the shot glass dope solution.
10) pump solution into nose, about 1-2 sprays each minute to minimize dripping into throat. takes about 5 minutes to finish, then the very last "puddle" that can't go up the straw can be squirted in with a small eye dropper.
-----------------------
So, does this seem like an effective and efficient way of doing this. What would you change, such as amount of water or soaking time, etc?
