• 💊 OTHER DRUGS 💊 Welcome Guest
    Posting Rules Bluelight Rules
    Notable Threads 1 Notable Threads 2
    Dangerous Combos Addiction Support
    Emergency Services Benzo Guide v.1
    Addiction Stories Scary Case Studies
    Biology, Pharmacology & Drugs 101
  • Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Cocaine Crack Cocaine - Freebase Megathread

ImperialTyranny said:
shooting, im talking bout crack not coke man once I make some. I've shot n snorted plenty of coke in my time but only had crack a couple times and pretty sure I either didn't make it very well or the coke I made it from was below par and really wasn't that impressed smoking or shooting it. Or I wasnt smoking it properly, my usual drug of choice is meth or heroin and I've only had coke a few times that was actually good enough that I actually felt strongly enough to be impressed with. Most of the street coke here is absolute rubbish and even from the good connects I have theyre coke is pretty hit or miss with quality, I generally only use it when I am shouted or theres some leftover from helping a mate out though.
Click to expand...
Did u inject crack?? How? Didn't you made it cocaine citrate or smth?
 
aftershocknrock said:
brother this is easier than it sounds. Get some acetone (perfume free) and some epsom salts (magnesium sulphate) from the pharmacy.

Put the epsom salt in the oven @50c for an hour to dry, then mix with acetone shake well and seperate. mow you have anhydrous acetone.

Wash the coke in the acetone the cuts (some) should dissolve in the acetone filter the solids through a coffee filter, squeezing gently to try get execss acetone out.

now get a wax coated paper plate, the kind you get for kids birthday patys or whatever. Spread the washed coke on the plate to dry. After an hour or two you should be able to see two distinct powders on the plate, shiny cocaine flake and dull cut.

Now very gently tilt the plate and tap the edge, the shiny coke crystal will slide off the plate while the dull cut sticks to the surface. You now have very pure cocaine.
Click to expand...
Issue is, I haven't done the acetone wash. So I remained with the crack. 0.88g out of 1g so there are definitely some cuts in there that I don't know how to remove.

should I make it back into coke and remake the crack?

should be pretty easy right? Just add citric acid?
 
bunny22 said:
Issue is, I haven't done the acetone wash. So I remained with the crack. 0.88g out of 1g so there are definitely some cuts in there that I don't know how to remove.

should I make it back into coke and remake the crack?

should be pretty easy right? Just add citric acid?
Click to expand...
freebase cocain is soluble in acetone so you would have to convert to Hcl which is a pain and not worth it if you starting from street crack bro
 
ImperialTyranny said:
no not crack just coke but I was under the impression there is a way to shoot crack but I may be wrong
Click to expand...
You can shoot crack. I use vinegar, lemon juice or powdered kool-Aid. Just remember to use a lighter colored Kool-Aid or it’ll be hard to see the blood flow in the rig. Man it hits so hard when that rush comes in!!! I love it. I’m actually smoking crack right now. I wish I had a rig.
 
aftershocknrock said:
freebase cocain is soluble in acetone so you would have to convert to Hcl which is a pain and not worth it if you starting from street crack bro
Click to expand...
it is indeed very possible to shoot crack. I’ve done it a lot and I love it. Just have to crush it up in some vinegar, lemon juice or powdered Kool-Aid.
 
warrenbuffetjr said:
it is indeed very possible to shoot crack. I’ve done it a lot and I love it. Just have to crush it up in some vinegar, lemon juice or powdered Kool-Aid.
Click to expand...
No - It's impossible to shoot crack, it's insoluble in water.

That process turns it back to cocaine hcl, which makes it shootable / snortable. It is not crack anymore

. Use acetic / ascorbic acid (vit c) if you must do this - not vinegar / lemon juice
 
InYerPipe said:
Hey man the same way some people look down on cannabis and call it 'dope', the people who want to stigmatise rock smokers call it 'crack'. I tend to call it base.

Although some of us probably should be stigmatised sometimes. Especially if we're looking for that last piece that we're sure we stashed away under the bookcase here...or maybe it fell under the bed...or didn't I leave some on the counter for later...or maybe I'll just hit the screen one more time ('cause maybe I missed a little bit around the edges)...wait what was that noise? I think I heard someone upstairs...
Click to expand...
Free-base -> made via Ammonia way, rotten chemical to work with.
Better end product. Nl had back then only freebase.

Crack via Baking-Soda [food]* the advantage lower risk making it.
Sodium Bicarbonate, is the lazier/ easy way.
Safer but the end result, the quality/ experience less.
If comparing from info people who use it.

But no personal experience, but know Ammonia.
So when DIY i d make Crack not Freebase,
just that disgusting Cat piss smell. 👃

Both are slang so different names are allowed,
both contain freebase Cocaine. The scientific name.

* Read about people baking Muffins with Crystal,
cleaning Soda. Resulting in pukefest. NOOBS.
 
Last edited:
ageingpartyfiend said:
No - It's impossible to shoot crack, it's insoluble in water.

That process turns it back to cocaine hcl, which makes it shootable / snortable. It is not crack anymore

. Use acetic / ascorbic acid (vit c) if you must do this - not vinegar / lemon juice
Click to expand...
I do it all the time and I’ve done it for years. It’s not that hard to figure out. The baking soda gets left on the spoon or cap.
 
Antiprosynthesis said:
I posted some links in my previous post and a screenshot, saying first how pure coke and other drugs are in antwerp, also about how pure drugs are in amsterdam and besides being the no1 producer of certain drugs worldwide our other drugs are really high purity and also that more than one drug here broke every record in the world with amazingly high purity.

The drugs in antwerp are described as horrifying pure.

Since I posted this nobody has anything to say it seems...
Click to expand...
In Amsterdam and in the 80's, I experienced the same product purity across the board, have not been to Antwerp, but will add it to destinations of interest!! For sure!!
Any other travel trips? Please share,,,,,,great fuckin post as far as I'm concerned, thanks for sharing!!
Peace brutha
 
ageingpartyfiend said:
No - It's impossible to shoot crack, it's insoluble in water.

That process turns it back to cocaine hcl, which makes it shootable / snortable. It is not crack anymore

. Use acetic / ascorbic acid (vit c) if you must do this - not vinegar / lemon juice
Click to expand...
I don't wanna be that guy but it's only hcl if done with hydrochloric acid otherwise its, for example if using vinegar for acetic acid, cocaine acetate
 
I know what I’m about to say has been beaten to death on this thread. I’ve tried converting cocaine hcl into a base a couple times and failed miserably. I’ve looked around quite a bit and everyone has their own unique methods in regards to using bicarbonate. I understand 1g to 0.3g bicarbonate seems to be an agreeable ratio. When applying these compounds to the spoon do you just dump both in there regardless of order? Should I mix them up like one would with flour and sugar for a cake then add enough water to create a solution?

I believe my issue is that I applied way too much heat. Is the low and slow heating method the way to go? I shouldn’t be stirring anything as the initial reaction takes place correct? Only use a metal nail when the oil begins to form and collect it all into a single piece? Also is shocking it at the end with some tiny pieces of crushed iced or a few drops of cold water recommended?

I apologize as I know all these questions have been answered many times, but I had a long day and was hoping to obtain some advice. I’m only getting a gram from a friend, but it’s straight off a Colombian brick. I presume the higher the quality the easier it is to convert as other impurities won’t hinder the process.

I really don’t want to have to IV it. I’ve done plenty of speedballs, but one time my friend prepared a shot of straight cocaine and I thought I was going to die. I threw up violently. It was paradoxically horrendous yet disturbingly pleasant.
 
higherconciousness said:
I know what I’m about to say has been beaten to death on this thread. I’ve tried converting cocaine hcl into a base a couple times and failed miserably. I’ve looked around quite a bit and everyone has their own unique methods in regards to using bicarbonate. I understand 1g to 0.3g bicarbonate seems to be an agreeable ratio. When applying these compounds to the spoon do you just dump both in there regardless of order? Should I mix them up like one would with flour and sugar for a cake then add enough water to create a solution?

I believe my issue is that I applied way too much heat. Is the low and slow heating method the way to go? I shouldn’t be stirring anything as the initial reaction takes place correct? Only use a metal nail when the oil begins to form and collect it all into a single piece? Also is shocking it at the end with some tiny pieces of crushed iced or a few drops of cold water recommended?

I apologize as I know all these questions have been answered many times, but I had a long day and was hoping to obtain some advice. I’m only getting a gram from a friend, but it’s straight off a Colombian brick. I presume the higher the quality the easier it is to convert as other impurities won’t hinder the process.

I really don’t want to have to IV it. I’ve done plenty of speedballs, but one time my friend prepared a shot of straight cocaine and I thought I was going to die. I threw up violently. It was paradoxically horrendous yet disturbingly pleasant.
Click to expand...
Doesn't matter in what order you put into spoon, just roughly mix the powders together.

Heat slowly, don't stir, when oil forms don't worry too much about the nail - you can use a knife or anything really and even if the oil does not collect into a single blob you can just leave the whole thing to cool and you'll still get your crack

You can shock it with iced water or not, no real difference ime but I always did just to cool things down faster.

If you have hq coke the best ration is 1:5, 1:4 at the very most. Better still, use ammonia but be careful to give a good water wash as a last step
 
ageingpartyfiend said:
Doesn't matter in what order you put into spoon, just roughly mix the powders together.

Heat slowly, don't stir, when oil forms don't worry too much about the nail - you can use a knife or anything really and even if the oil does not collect into a single blob you can just leave the whole thing to cool and you'll still get your crack

You can shock it with iced water or not, no real difference ime but I always did just to cool things down faster.

If you have hq coke the best ration is 1:5, 1:4 at the very most. Better still, use ammonia but be careful to give a good water wash as a last step
Click to expand...
Thanks for the feedback. It sounds like I’m on the right track. I think last time I tried doing it, the quality of the coke was mediocre at best and I exposed it to too much heat and didn’t give the reaction enough time for the CO2 to form and dissipate, thus I didn’t obtain the oily freebase and was left with burnt baking soda rocks laced with cocaine.

I’ll try to keep it simple by using minimal heat and not interfere with the process. The cocaine, that should arrive any moment, is of exceptional quality. I’ll try using a half a g for my trial run. I just found a perfect one hitter glass stem last night. I’ve heard some conflicting things on what type of metal mesh to use. Some say only chore boys while others claim brass screens are safer. I have both, but I’ve read that just packing it between ash works quite well too.

I got a good feeling about it this time. I’ve done crack a handful of times, but never got a proper hit. Hopefully with everyone’s recommendations and support, I get to the promise land. Wish me luck
 
higherconciousness said:
Thanks for the feedback. It sounds like I’m on the right track. I think last time I tried doing it, the quality of the coke was mediocre at best and I exposed it to too much heat and didn’t give the reaction enough time for the CO2 to form and dissipate, thus I didn’t obtain the oily freebase and was left with burnt baking soda rocks laced with cocaine.

I’ll try to keep it simple by using minimal heat and not interfere with the process. The cocaine, that should arrive any moment, is of exceptional quality. I’ll try using a half a g for my trial run. I just found a perfect one hitter glass stem last night. I’ve heard some conflicting things on what type of metal mesh to use. Some say only chore boys while others claim brass screens are safer. I have both, but I’ve read that just packing it between ash works quite well too.

I got a good feeling about it this time. I’ve done crack a handful of times, but never got a proper hit. Hopefully with everyone’s recommendations and support, I get to the promise land. Wish me luck
Click to expand...
I’ve had the best luck using a mesh screen - copper is ideal if you can find it because it’s not as toxic as steel - and I cut a small portion off a copper wire pot scrubber (less toxic than steel wire) compress it into a little disc shape, put that on top of the screen and then put my crack on top of that. But I use a small pipe with a glass stem and a small metal bowl. I’ve not been able to find cocaine that is high-quality enough to vaporiser via indirect heat in an all glass pipe.

Official chore boy contains soap which you definitely don’t want, and anything steel contains toxic chromium which is not great for your lungs. I’ve never used ash but I despise cigarettes so there’s no way I could tolerate the smell/taste.
 
You must log in or register to reply here.
Top