Converting liquid to powder ?

[Kishka]

Hej,

I'm having a small problem. I received a vial filled with some 2C-B (Just one trip, about 25mg) but during the travel the vial bounce in my pocket and now most of the powder is stuck to the surface of the vial 8(

I'm unable to catch the powder, it's too thin A friend told me to add some alcohol and then dissolve the solution in a plate to bring the powder back.

I have totally no clue to do that 8)

What's the process like ? I only have vodka 40 percent alcohol. I need to add some to have a liquid solution and then, how could I heat the liquid ?

Tack så mycket

 

[Morphling]

I don't know how heat sensitive 2C-B is, but it's as easy as adding the alcohol to the vial, shaking, and leaving it out in a container to dry, scrape up, and you have your substance.

Also, you could purchase a micro-spatula from a chemical storehouse online, to scrape it out of the vial.

 

[Kishka]

Hi,

Thanks for your reply ! How do I do ? I need to put the alcohol in a plate and leaving out ? How much time should I wait approximately ? Should I need heat ?

Thanks!

 

[Morphling]

No problem at all. Use the highest proof alcohol you have, and yeah leave it out on a plate. Could take a few hours to dry out, or overnight. I'd put it on a hotplate on the lowest setting to speed it up a bit.

 

[lamanogaucha]

If you're certain that the amount is 25mg (+/- ~2mg) and if your intention is to ingest it within a few days, then all you need to do is put some distilled water in the vial, shake it a bit, and drink it! It will taste nasty and bitter, but that will go away after a few minutes, especially if you follow it up with a little iced tea or some other soft drink.

 

[Kishka]

Thank you also lamanogaucha, I will do that! But the process of Morphling is very good, I've learn something today

I still have a question about this by the way. If I need to do this process in the future so I should do the following:

1. Take the liquid solution
2. Put it on a plate
3. Leaving overnight
4. Scrap up and take the substance

Well, Could I take the plate and put the liquid solution in the microwave for example ? Will it be ok ? I need some explanation about the heating process. What can I use and which one I can't ?

I will take the 2C-B like lamanogaucha suggest but I'm still interested by the first option just in case for the future

Thanks VERY MUCH ! :D

 

[lamanogaucha]

No! Don't nuke it! Let it dry naturally!

The hotplate idea is OK but if you use too much heat, it could damage the material. Maybe an electric blanket set to very low is better.

You're welcome regarding my DH2O suggestion. BTW, did you read my post in your DOI warning thread? I mentioned four points that are important, so you should always keep them in mind!

 

[choco1ate]

you could just plug the liquid solution. im only saying that because its way smoother(faster comeup, less body discomfort). and so much more intense that oral seems like a waste in comparison. dont do it unless youre prepared to trip absolute balls

 

[lamanogaucha]

As long as it's DH2O and not "highest proof alcohol", then yes. That having been said, 25mg of plugged 2C-B is pretty strong indeed for most people, and Svenika being rather small (at least as far as weight goes)... You get my point, I'm sure. Anyhow, I much prefer oral consumption over plugging, but different strokes for different folks and all that jazz.

 

[Kishka]

All right I'm gonna drink the solution.

Do you have an approximative idea for the timing regarding the solution to powder conversion ?

Thanks again

 

[lamanogaucha]

As Morphling mentioned, high-proof alcohol solution to powder conversion will take several hours. The length of time required to complete this process depends on the original alcohol/powder ratio, temperature and air humidity. Other factors such as barometric pressure and altitude play a role as well, but you need not worry about such details.

 

[Venrak]

Drinking it would be the easiest thing. Water solution, that is.