Yes. If you absolutely have to. First put some weed or inert material in the pipe. Then the DMT. Next, put some ash or something that wont burn and smash it down a bit, but not hard. Then when youre ready to smokke, light the lighter but dont touch it to the material, DMT burns at a low temperature so scorching is a risk if you dont. Yoiu;ll know when you are hitting it, it tastes like plastic moth balls.
Alternatively, use THE MACHINE
The only materials needed to fashion The Machine are a small glass
bottle and a bit of extremely coarse steel wool, as is used for scrubbing
pans. For the bottle, a single-serving Hennessy Cognac bottle works
great, due to its long neck coupled with a handy pre-formed weak spot
in the bottom. After breaking or drilling a small hole in the bottom of
the bottle, a bit of steel wool is rolled into a plug and then pushed into
the neck. Any loose bits inside can be compacted gently by using a probe
inserted through the hole broken in the bottom. This is the finished
device ready to be charged.
To charge The Machine, enough for one or more good doses (the more
the better) is directly applied to the surface of the steel wool at the mouth
of the bottle. The neck of the bottle is then gently heated just enough to
cause the alkaloid to melt into the steel wool plug. If not intended for
immediate use or if intermittent use is desired the cap can be replaced
over the charge to protect it. Freshly applied DMT resin can be prevented
from contacting the cap by placing a small piece of paper between
it and the cap (rolling paper works well for this). The Machine
can also be charged for multiple users by placing a much larger quantity
on the inside of the plug by dropping it through the broken hole.
Charging is done the same way, by gently heating the neck until the
plug absorbs the alkaloid.
To use The Machine, simply point the neck downwards and heat the
steel wool plug from below with a lighter, while slowly inhaling through
the hole made in the bottom. (Take care not to overheat and ignite the
steel wool.) Rotating the bottle while heating will help it volatilize evenly.
The high surface area and heat distribution of the steel wool traps the
liquid alkaloid, both retaining it and driving it into vapor. This trapping
effect also permits the pipe to be simply set down, then picked up
and reheated, as needed.
