best way to crush an oxy

[Anon54]

I seen someone put an oxy on a spoon add water then heat it with a lighter, crush it with the flat plunger part of a needle & repeat untill it was dissolved in the water.
he injected it. I was explaining that the bioavailablity taking it orally outweighs the risk of shooting it but he didnt care.
anyways i think the OCs in aus aren the knew OP ones or whatever they're called & can be crushed & swallowed to get instant release.

I was just wondering if this procedure would be a good way of dissolving the pill. not to shoot it but to just swallow the liquid from the spoon.

I just chewed up to 40mg OCs but even though im only a fairly regular codeine user even 80mg which i only take a few times a month barely does anything. Is it because chewing it up simply isnt very effeciant?

is there some kind of better way of breaking the time release?
do u think heating it on a spoon & dissolving it in water would be a good idea, or does the heat damage the oxycodone?

anyway u'll wait another 1/2 & see how a feel. I wish I didnt have a meal before takiing them

 

[BrokedownPalace]

If they are the normal formulation of oxycontin, simply crushing into a fine powder and then parachuting it will be just about the same thing as crushing and dissolving in water. The absorption rate of each method is quite fast and should defeat the majority of the time release. The fact that you took them after eating a meal most likely affected it much more than the fact that you chewed it.

If you are injecting them, absolutely DO NOT add heat, as all it does it facilitate the binders and fillers getting into your solution, and then once it cools they precipitate back out into particulate matter, which will float around your shot/blood stream. Opiates are very soluble in cold water. all you need to do is crush into powder, add to spoon, add water, stir thoroughly, and then filter properly with a micron filter. Heat just adds increased danger/risk to your shot.

 

[nAON]

First of all, take off the time release. Do this by licking it, or runnin briefly under some water, then just rubbing the coating off with a bit of tissue, towel, whatever. Make sure the pill is totally dry.

Then what I did was first, slice it in half and quarters (for easier crushing). Then, fold it up in a piece of paper, make sure to fold all the edges up (this is to prevent bits of oxy flying everywhere). Then I would just hit roll something smooth and heavy over the paper, like a mug, can, rolling pin, etc. to crush it all up.

Chewing isn't gonna be very good mostly because bits are gonna get stuck in your teeth, it doesn't taste great, and isn't nearly as efficient since you're not crushing it down as much as possible.

 

[Anon54]

i have those alcohol swap things that ppl use before shooting. i suppose they would be effective at taking off the coating?
if i get oxys again i'll wrap em if paper & smash it with the handle of a screw drivers. thats how I crush my codeine pills after putting them in water works well.
it's a pitty ya they just dont dissolve in hot water. boiling water would surely be a bad idea

 

[BrokedownPalace]

First of all, take off the time release. Do this by licking it, or runnin briefly under some water, then just rubbing the coating off with a bit of tissue, towel, whatever. Make sure the pill is totally dry.

The coating is not the time release. The time release is a built in matrix inside the entire pill. The coating is simply a color coded way of identifying the strength of the pill.

 

[nAON]

Yeah, just force of habit to call it 'time release coating'

And anon, the alcohol things aren't really necessary. Just lick your fingers and rub the pill with em, that's all you need to do really.

 

[Anon54]

^^ok i'll just wrap it into some paper next time & smashed it till it's like dust. does it all get stuck to the paper or do ya just paracute the paper & all?

 

[nAON]

Usually I just make sure to dry the pills very thoroughly before crushing it, so it's completely dry powder after being crushed. Then just pick it up with fingers or lick the powder up though if you don't like the taste/texture, yeah just chuck it in a rizla.

 

[Anon54]

^^rizla. if i put it in like an envelope or something & crush it up with it get all stuck to the paper or does the powder just tip out?
just wondering if i have to swallow the paper or not

 

[Anon54]

i dunno how u can do it. those little oc tablets are pretty tough i dunno how ya can smash them up.
i once tried putting 1 in warm water & tried hitting i with the handle of a screw driver but it wouldnt crush up.
i ended up just puring the pill into my mouth, chewed it & drank the water.
might just stick with chewing em. i heard of something called a pill crusher on here once.
they used to have pill spliter sold at the pharmacy. they were perfect for fast splitting of the old Nurofen + pills back in the day where the codeine was only in one side. Much easier than cwe & probably way more effecicant.
one day they are probably gunna sell only pills with dissolvable apap. i think they've already created dissolvable apap. hope that doesnt happen. kinda my emergency drug

 

[pally pete]

I seen someone put an oxy on a spoon add water then heat it with a lighter, crush it with the flat plunger part of a needle & repeat untill it was dissolved in the water.
he injected it. I was explaining that the bioavailablity taking it orally outweighs the risk of shooting it but he didnt care.
anyways i think the OCs in aus aren the knew OP ones or whatever they're called & can be crushed & swallowed to get instant release.

I was just wondering if this procedure would be a good way of dissolving the pill. not to shoot it but to just swallow the liquid from the spoon.

I just chewed up to 40mg OCs but even though im only a fairly regular codeine user even 80mg which i only take a few times a month barely does anything. Is it because chewing it up simply isnt very effeciant?

is there some kind of better way of breaking the time release?
do u think heating it on a spoon & dissolving it in water would be a good idea, or does the heat damage the oxycodone?

anyway u'll wait another 1/2 & see how a feel. I wish I didnt have a meal before takiing them

The way i have found it to chop in half with a razor blad ea nd then into a quarter and then crush using some thing hard (maybe the bottom of a glass bottle or something similar) and chop and chop with the razor blade until a fine a powder as possible then eat the contents washed down with a nice flavoured drink, maybe a cup of tea to possible speed up the absorption of the oxy in your gut?

Although recently ive found my best method yet, chop as mentioned above into quarters or smaller if possible the put contents into an old weed grinder ( obviously not one i use to grind weed with! ) then grind as much as possible and you should be left with the finest powder possible... any left over oxy dust stuck in the grider carefully prize out with a blade or sharp object and the as mentioned before ingest with a tasty drink

Good luck and stay safe

 

[Oxide]

answered and closed.