throwawaythatthrow
Greenlighter
- Joined
- Feb 12, 2014
- Messages
- 1
So on my last methylphenidate refill, I got 20mg pills from a different manufacturer than what I normally get. The new ones gel up to the point that I'm using several bits of cotton for one shot of a few pills.
Then tonight I got a 20pack of rigs, but I didn't check them as in the past they've ALWAYS given me 1cc. Anyway, unless I use a lot of water and heat the shit out of the crushed pills (which I know not to do, as fillers can re-solidify (and yes I know I need to get some micron filters, but currently I've just got cotton). What would be the easiest way of getting a clean solution into these tiny motherfuckers while wasting as little as possible? I was thinking of filtering first using a 1cc rig, then squirting that solution into a separate spoon and heating it until enough water had evaporated to fit into the small rigs, and refilter. Will doing this burn up the methylphenidate too? Can I avoid this by heating slowly, and if so, how slow? Any other ideas are greatly appreciated, as this is becoming a real hassle lol.
Then tonight I got a 20pack of rigs, but I didn't check them as in the past they've ALWAYS given me 1cc. Anyway, unless I use a lot of water and heat the shit out of the crushed pills (which I know not to do, as fillers can re-solidify (and yes I know I need to get some micron filters, but currently I've just got cotton). What would be the easiest way of getting a clean solution into these tiny motherfuckers while wasting as little as possible? I was thinking of filtering first using a 1cc rig, then squirting that solution into a separate spoon and heating it until enough water had evaporated to fit into the small rigs, and refilter. Will doing this burn up the methylphenidate too? Can I avoid this by heating slowly, and if so, how slow? Any other ideas are greatly appreciated, as this is becoming a real hassle lol.
