4-Fluoroamphetamine injection questions

[kewagi]

Good day, Bluelight! I've been lurking this board for quite some time, and now I stumbled upon a question that neither Erowid nor Aunt Google could answer, and so I hopefully turn to you.

What would it take to turn 4-FA powder into an injectable form? Is mixing it with water enough, or would it take some additional steps? And would anyone have a recommendation for a 'light' dose, assuming a very pure ( >99,5% ) substance and little to no tolerance? Thanks in advance!

 

[LivingOnValium]

^mixing it with a small amount of water should do the trick.

 

[kewagi]

Just did - mixed 50mg of 4-FA with 1,5ml of saline solution. I wrote a mini-report here. Thanks!

 

[titstypedthis]

wow, i needed 150mg : /

 

[clara]

I remember this and I did around 100mg at a time.

 

[kewagi]

A little over 3 hours later, and the effects are almost gone. I'll take a break, get some fluids, then try again with 125mg.

 

[clara]

I am in no way saying to do that much! That's just the amount I was using at the time.

 

[kewagi]

don't worry, I did not assume you were recommending anything I worked my way up to 150, but the main difference seems to be duration - that might be because of tolerance, though. Also, sometimes, the stuff does burn - but it's bearable.

 

[titstypedthis]

yeah its not like a "omfg did i just inject sulphuric acid?" feeling, its more like your veins warm up a little.

although mine was in like 30 units, not 1 and a half mls

 

[fryingsquirrel]

Yrah that's far more water than is needed.

 

[kewagi]

30 units? Whoa. I found that 100mg of 4-FA will easily dissolve in half a ml if heated a bit. There's really no need for such a large amount

 

[titstypedthis]

sorry i'm too used to IV'ing

30units is 30cc, 1/5th the amount you used...