2c-e liquid measuring

[freelove4everx]

i want to suspend 100mg of 2ce in the least possible volume, iv read y can dissolve 50 in 1nml in strong ethyl alcohol or just water wen heated.. ideally id like to have the dose like 100mg divided into 5 20mg liquid solution, as i had any 2ce for about 2 years, so i really dont want to mess up the dose. so wat would do for a good way to heat up for his concentration that is meant for oral consumption, so having a semi big vial is okay. of course i measure with syringes for theses purposes nowadays.
thanks in advance
shaggy out

edit: would something like 10 or maybe 20 ml dissolve well with 100mg?

 

[solistus]

A friend of mine tried a very high concentration (I believe it was 50 or 100mg 2C-E per 1mL of solvent), but I think that's overkill unless you need to store huge amounts of it. I usually dissolve 2Cs at a concentration of 20mg per 1mL solvent. I prefer using either alcohol or a mix of alcohol and water (like, say, vodka), to ensure that the solution stays sterile for long periods of time. If you only use water, it might start growing all sorts of fungi and microbes, just like any stagnant water would. 20mg/1mL is a high enough concentration that even a very high dose will use a miniscule volume of solvent, so even if it's pure Everclear you don't have to worry about getting a noticeable dose of alcohol.

 

[freelove4everx]

so using 5ml for 100mg like u suggested, i would probably use 80-100 proof vodka, will have to heat it to get it to dissolve? if so should i start with 10ml of liquid then heat it down or how should i do that. and u also mentioned water/vodka mixture, should i do that. and fyi this suspension will be used within a month tops, so long term storage isnt the issue. thank you. and like ststated before i know that that much liquor will not effect the 2ce effects.

 

[solistus]

Vodka works fine. I like to use a mix of everclear and distilled water, but if I can't get everclear I just use vodka. I prefer everclear and distilled water because they evaporate off cleanly; vodka does for the most part, but lower quality vodkas have trace amounts of other stuff that might not evaporate off completely and I'm a purist. That's only relevant if you care about being able to evaporate it back to dry powder.

It should dissolve at room temperature pretty easily at that concentration. A friend of mine stored some in the freezer (which isn't necessary, as 2C-E is extremely stable and won't degrade at room temperature) and some of the 2C-E precipitated out of the solution, but he just warmed the vial in the palm of his hand and swished it around a bit and it dissolved again.

 

[freelove4everx]

I just dissolved my freshly arrived 100mg( i measured it myself to make sure it was accurate) into a 13.7ml glass vial with a screw on very tough plastic lid, i boiled a shot glass and the vial, just disinfected the lid really well. i then took 5ml of the boiled water and carefully measured the freshly boiled water into the vial, i then put 5ml of 80 proof "Absolut Raspberri" vodka( very little raspberry flavor in there.) anyway then i slowly dissolved the 2ce, prolly lost 2-4mg in the transfer from bag to vial but no more than that, i just finished the process about 10 min ago, it seemed to dissolve after minimal shaking, there almost looks like theres at times like after i shake it little itty bits of not 2ce but air pockets like ud see with this proof vodka. So my question is did i perform this well, and are these tiny suspended specks that semm to 95% go away after a min after any shaking. so am i cool? FYI all of this liquid will be consumed as is, in care carefully measured 1mg/10cc concentration. thank you for your help, please tell me if theres anything i should know, fyi also this val will be used within a month tops so longtime storage isnt an issue

 

[Solipsis]

Be advised that with very small volumes of solvent evaporation becomes an increasingly significant problem.

If at all possible, I would really try to stick to 1,2 or 5 mg/ml - 10 if you must.

Remember to make your alcohol content at least 20% or 40 proof.

 

[solistus]

Yeah, watch out for evaporation. I try and keep track of exactly how much should be left, so after a long break from use if I take it out and notice that I've lost a mL or two to evaporation, I can either add the missing volume of liquid back in or just calculate the new concentration with some simple arithmetic.

Also, I imagine this was a typo but just in case: what you have is 10mg/1cc, not 1mg/10cc

 

[freelove4everx]

no theres no typo there, i made sure it was a 1mg/10cc concentration solution. theres a long reason why i made the solution the way i did.
or in case ur misunderstanding, i mean 10 units on a 1ml syringe. so 10units/1mg

 

[solistus]

no theres no typo there, i made sure it was a 1mg/10cc concentration solution. theres a long reason why i made the solution the way i did.
or in case ur misunderstanding, i mean 10 units on a 1ml syringe. so 10units/1mg

Hrm?

cc means cubic centimetre. 1cc = 1mL.

You took 5mL water and 5mL vodka, for a total of 10mL. You dissolved 100mg of material in it. That's 10mg per 1mL.

 

[freelove4everx]

^^^^ yes, i must have been stoned that is exactly wat i meant. The only thing got that definitions mixed up, i define a cc as just the small shit up to 10 on a 1ml syringe. either way it works out, went well. it truelly reminded me of why i love 2ce so much, next time in the next week or two im going to put a gram with 50 maybe 25ml of 50%water/50% ideally everclear solution. from now im only keeping liquid solutions. quick, easy to dose, and thanks for me using half water drying it back up to powder seems terrible. it forces me to take a drug i=that i love is the way it was meant to take