hotzenplotz
Bluelighter
- Joined
- Aug 8, 2006
- Messages
- 59
My question to you chem experts: if one received 2-fluromethcatinone that has a beige color and gets sticky and wet when kept outside the baggy, is this due to it being hydroscopic or bad synth or is it not dry enough?(acetone rests)
What is more worrysome is that some of the yellow clumps get green when dried in a backingoven. if you but it back into the baggy and crush the clumps it gets one color again. i know it is hard to judge by this discription, but what would u say?
i read about 2-fmc being hydroscopic but the color change is a little strange. Of course normally u should dry it at air but then it seems to absorve whater ;-)
What is more worrysome is that some of the yellow clumps get green when dried in a backingoven. if you but it back into the baggy and crush the clumps it gets one color again. i know it is hard to judge by this discription, but what would u say?
i read about 2-fmc being hydroscopic but the color change is a little strange. Of course normally u should dry it at air but then it seems to absorve whater ;-)
