I have become interested in IV administration of MDMA.
I have many different Diabetes supplies that I could use to administer the MDMA intravenously. The powder that I get is very fine, white as snow, and indeed looks to be a crystalline powder; it's taste is very bitter and distinct and it is what MDMA is supposed to taste like. Every time I have rolled, it has been with this powder from the same supplier (Which happens to come from a store in my city that constantly has MDMA available, so I assume it is made in a lab). I have not tested the powder with a testing kit, but every time my friends and I have consumed a capsule with ~100mg of this powder, we all have experienced effects and side effects brought on only by MDMA. One of my friends rolled very hard, even though some of the powder fell out of her capsule (she cut a little bit of it to taste test it, then the capsule fell on it's side; she had a little more than half a capsule that she consumed, and she felt the MDMA come on strong). I also have a milligram scale to properly measure out the doses for injection.
So if I was to decide to inject said powder, I have some questions concerning it.
1. Should I get a testing kit and test the powder to ensure that MDMA is present in the powder?
2. Should he do and acetone wash to further clean the powder?
3. I have used from 100mg of this powder to about 300mg of the powder; all times orally. What would approximately be a good starting dose for IV administration, if my preferred oral dose is around 150 mg?
4. What is the proper way of dissolving the MDMA powder into a solvent? I have heard of anywhere from dissolving it into water in a spoon by adding heat, to just mixing it with water.
5. Would a 2 ml syringe be sufficient for dissolving x amount of MDMA?
Any input or advice from people who have tried IVing MDMA is greatly appreciated!
I have many different Diabetes supplies that I could use to administer the MDMA intravenously. The powder that I get is very fine, white as snow, and indeed looks to be a crystalline powder; it's taste is very bitter and distinct and it is what MDMA is supposed to taste like. Every time I have rolled, it has been with this powder from the same supplier (Which happens to come from a store in my city that constantly has MDMA available, so I assume it is made in a lab). I have not tested the powder with a testing kit, but every time my friends and I have consumed a capsule with ~100mg of this powder, we all have experienced effects and side effects brought on only by MDMA. One of my friends rolled very hard, even though some of the powder fell out of her capsule (she cut a little bit of it to taste test it, then the capsule fell on it's side; she had a little more than half a capsule that she consumed, and she felt the MDMA come on strong). I also have a milligram scale to properly measure out the doses for injection.
So if I was to decide to inject said powder, I have some questions concerning it.
1. Should I get a testing kit and test the powder to ensure that MDMA is present in the powder?
2. Should he do and acetone wash to further clean the powder?
3. I have used from 100mg of this powder to about 300mg of the powder; all times orally. What would approximately be a good starting dose for IV administration, if my preferred oral dose is around 150 mg?
4. What is the proper way of dissolving the MDMA powder into a solvent? I have heard of anywhere from dissolving it into water in a spoon by adding heat, to just mixing it with water.
5. Would a 2 ml syringe be sufficient for dissolving x amount of MDMA?
Any input or advice from people who have tried IVing MDMA is greatly appreciated!
