ThePredecessor
Bluelighter
- Joined
- Jul 23, 2014
- Messages
- 70
50mg if Hexen plugged with 30mg U4 makes for the most pleasurable RC speedball lol
i've had two batches of it
the first one mentioned in my previous post was very coke like and looked like tiny white/transparent crystals
second was a tan powder which felt like your average cathinone/pyrrolidinophenone aka nothing special
batch one.... if I could get my hands on more...
Beside the fact that you state it instantly makes you paranoid, which isn't at all how I remember it, what was your experience like? Did you use it IV?this the hexen mega thread? it has the most post and authors outside a region specific thread. want to see something crazy ...
![]()
hexen straight out of baggie from reputable vendor.
![]()
after iso wash. about 80m dissolved in 10ml of 91%, run through a presoaked chemex paper that i folded to be two-ply and fit into a v60, dried under bonsai lamp. yield was about 50 percent.
![]()
![]()
after wheel filter. about 100mgs dissolved in about 10ml of bacteriostatic water, pushed through a .22um, 25mm, PES wheel filter that had pre-flushed bacteriostatic water to minimize retention and because i hear that cleans the filter (which makes no sense to me), dried under lamp. yield was about 20 percent. keep in mind, a PES wheel is designed to retain 90 something percent of the good stuff and at .22mm filters particles as small as bacteria. 25mm is a appropriate size for for 10ml.
to be clear, each filtered or washed sample only went through one of the processes. which a new piece of the vendors material, from the same batch and baggie. neither was cleaned one way and then the next
images can be click for full size.
PSA not only about hexen but vendors in general, no matter how big and reputable they are.
edit:
sorry, filter is pes not nylon. both materials are leaders among allowing desired ingredient to pass though ...
![]()
The percentage of active ingredients after filtration using different membrane filters (n = 3). For all ingredients, the amount before filtration was normalised to 100%
i do not understand how ptfe and nylon exceed 100 percent. maybe they count liquid the filter was pre-flushed with that ends up in the final product.
and 25mm retains ...
![]()
Values will vary depending on manufacturer and filter material. * hold-up volume is measured after air-purge.
i usually use 13mm filters for 1ml shots, but i've used 25mm for 1ml and lose so little volume i can hardly notice. nothing to brag about; saying my technique is not flawed to the point of impacting results. i don't think i "air purge" though; when the shot is in the new needle i stop. not trying to rupture the filter or push anything nasty through for a nominal amount of drug.
it was like crack with legs but the rush wasn't nearly as good. i mostly smoked it out of an oil burner or whatever you call those bulb meth pipes. don't iv it. even after cleaning it with the method i posted above it still feels pretty harsh like coke. i remember if the smoke got it your eyes if you waited too long for for the pipe to fill before inhaling, it would irritate them. only the first couple hits felt really good, like crack. then it was chasing that initial feeling. i only went through a gram of it, which after my above method was 200mg. which again, was almost but not quite 5x as potent as the uncleaned stuff. so some of whatever came out during the cleaning produced some sort of high, but not the good part of the high.Beside the fact that you state it instantly makes you paranoid, which isn't at all how I remember it, what was your experience like? Did you use it IV?