I did a small test batch, where I dissolved a meth into bacteriostatic water, filtered through a micron filter and injected directly into a brand new, sterile 10ml multi-use vial. I pre-calculated the weight of drugs, how much space it takes up in the rig (so for me .27gr was a ".35" as we call it) as well as how much liquid to dissolve), so I know the concentration. With that, I can calculate how much to inject.
I only did about 4ml of final solution, tried it out with a few friends, and it was awesome. We tend to use it at sex parties, and making a shot up is so unsanitary and time consuming... washing everything (silicone lube stays on everything!), crushing, getting into rig without spilling, mixing with water, shaking, warming up, shaking some more, still not dissolved (and all the while never really filtered). This time, clean rig, alcohol swab the top of the vial, draw to desired level, and done.
Is there a reason this would not work? I want to make up a full batch (full 10ml vial) but it will take just under 6grams, so I would like to make sure I'm not overlooking anything. Again, bacteriostatic water from the start, through .2micron filter and directly into unused, sterile multi-use vial.
I only did about 4ml of final solution, tried it out with a few friends, and it was awesome. We tend to use it at sex parties, and making a shot up is so unsanitary and time consuming... washing everything (silicone lube stays on everything!), crushing, getting into rig without spilling, mixing with water, shaking, warming up, shaking some more, still not dissolved (and all the while never really filtered). This time, clean rig, alcohol swab the top of the vial, draw to desired level, and done.
Is there a reason this would not work? I want to make up a full batch (full 10ml vial) but it will take just under 6grams, so I would like to make sure I'm not overlooking anything. Again, bacteriostatic water from the start, through .2micron filter and directly into unused, sterile multi-use vial.